Maintenance; Optional Accessories - Makita CG100D Instruction Manual

NOTICE:
1. Remove the holder cap, nozzle, and rubber ring
from the holder.
1 2 3 4
1. Holder cap Nozzle
Push the rod handle all the way until it stops.
Insert the tip of the holder into the caulking material, and then
1
1. Holder
4. Attach the rubber ring, nozzle, and holder cap by
1 2 3 4
1. Holder cap Nozzle
Rubber ring 4. Holder
Rubber ring 4. Holder
Caulking operation
Pull the trigger to feed the caulking material. Put one hand
under the holder to support the tool while operating it.
After the operation, wipe off the caulking material from the tool.
Be sure to remove the caulking material before it becomes solid.
NOTE: At the beginning of operation, set the speed
check how much amount of caulking material is fed.
NOTE: Depending on the type and conditions of
caulking material, it may not be fed at low speed. In
NOTE: If the caulking material is not fed, check the
following points:
until it becomes soft.
type of caulking material.

MAINTENANCE

CAUTION:
attempting to perform inspection or maintenance.
NOTICE:
cracks may result.
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
11 ENGLISH
-