Changing A Flat Tire - Honda Odyssey 2019 Owner's Manual

HANDLING THE UNEXPECTED
Driving on a significantly under-inflated tire causes the tire to overheat and
can lead to tire failure. Under-inflation also reduces fuel efficiency and tire
tread life, and may affect the vehicle's handling and stopping ability.
Please note that the TPMS is not a substitute for proper tire maintenance,
and it is the driver's responsibility to maintain correct tire pressure, even if
under-inflation has not reached the level to trigger illumination of the TPMS
low tire pressure telltale.
Your vehicle has also been equipped with a TPMS malfunction indicator to
indicate when the system is not operating properly. The TPMS malfunction
indicator is combined with the low tire pressure telltale. When the system
detects a malfunction, the telltale will flash for approximately one minute
and then remain continuously illuminated. This sequence will continue upon
subsequent vehicle start-ups as long as the malfunction exists.
When the malfunction indicator is illuminated, the system may not be able to
detect or signal low tire pressure as intended.
TPMS malfunctions may occur for a variety of reasons, including the
installation of replacement or alternate tires or wheels on the vehicle that
prevent the TPMS from functioning properly.
Always check the TPMS malfunction telltale after replacing one or more
tires or wheels on your vehicle to ensure that the replacement or alternate
tires and wheels allow the TPMS to continue to function properly.

Changing a Flat Tire

If a tire goes flat while driving, grasp the steering wheel firmly and brake
gradually to reduce speed. Then stop in a safe place. Replace the flat tire with
the compact spare tire. Go to a dealer as soon as possible to have the full-size
tire repaired or replaced.
Vehicles with a compact spare tire:
1. Park the vehicle on firm, level, non-slippery surface and set the parking
brake.
2. Shift to Park (P).
3. Turn on the hazard warning lights and set the power mode to VEHICLE OFF.
118 |
Getting Ready to Change the Tire
n
1. Remove the floor mat under the
second row seat and pull up the
carpet. Remove the floor lid.
2. Take the tool case out. Take the jack
and wheel nut wrench out of the
tool case.
3. Unscrew the wing bolt, then remove
the spacer cone. Remove the spare
tire.
4. Place the compact spare tire (wheel
side up) under the vehicle body,
near the tire that needs to be
replaced.
5. Loosen each wheel nut about one
turn using the wheel nut wrench.
HANDLING THE UNEXPECTED
| 119