Steamist TSC-450 Installation Instructions

Steambath Control
Important: Locate Publication No. 199 "Steam Bath Important Safety Instructions". This publication includes a Warning
label that the contractor must install on the wall near the entrance to the steam room in a highly visible location. This
!
label and its additional safety information are packaged with the generator in the envelope containing the installation
instructions. If it is lost or missing contact Steamist (201-933-0700) for a replacement Publication No. 199. This publica-
tion along with all documents must be left with the owner.
Control Features
1.
Timer control
2.
Temperature control
3.
Multiple user settings
4.
AudioSense™ control
5.
ChromaSense™ control
6.
AromaSense™ control
7.
ShowerSense™ control
8.
Other Miscellaneous settings
NOTE: For more details see separate operating instructions.
IMPORTANT: Control MUST be installed inside the steam room
for proper operation of the system.
Installation Instructions
1.
Pre-Installation - Control Location
The TSC-450 Control must be installed inside the steam
room. For convenience the recommended height from the
floor is four feet. If a TSSH is also installed we recom-
mend a height of 4½" feet when used for both steam and
shower. Provide a 1½" hole in the wall at this location (see
Figure 1).
IMPORTANT: Multi-conductor cable must be installed so
that the end will not be buried inside the wall. The unit will
Figure 1
IMPORTANT: Run the
Control Cable through
a ¾" conduit.
Required Inside
Installation
TSC-450 Control.
Locate away from the
direct line of shower
spray and do NOT
locate above
steamhead.
1½" Hole
located four feet
from the floor
IMPORTANT: The TSC-450 Control will only function with the current TSG steam generators.
12/15
To Steam Generator
Coupler
Double-Sided
Adhesive Pad
®
Total Sense Touch Control
Cleaning Instructions: Use a damp cloth and mild soap.
Do NOT use abrasive cleaners which might scratch the
surface or the base of the control.
not operate unless the control is installed.
2.
Electrical Rough-in
Remove the multi-conductor cable from the control
packing box. Carefully route the multi-conductor control
cable from the steam generator to the TSC-450 located
inside the steamroom (see Figure 1). Route multi-
conductor cable through a ¾" conduit to protect the cable
from damage and to facilitate replacement if necessary.
Figure 2 - Cable Installation on Generator
¾" Conduit
To Control
Modular Jacks:
All four modular jacks are
identical and work in
any combination.
Connect to any jack.
- 1 -
Installation Instructions
Model: TSC-450
IM
9:31
1 1 2 2
STEAM SHOWER STEAM SHOWER
Pub. No. 290-D
C US
®