Table of Contents
Advertisement
2 Introduction
Thank you for choosing the Labgear S201, a great aid to satellite dish and LNB alignment,
pre-loaded with masses of data and tools to make your job simpler and quicker.
Before you start please take time to read through this instruction leaflet which we hope will help
you get the most out of your meter.
3 Key Features
• Digital Satellite Meter compatible with DVB-S and S2 and DiSEqC 1.0/1.1 with 22kHz tone
• Displays both signal strength and signal quality with sound and light alarms to aid alignment
• Computes Azimuth, dish Elevation and LNB Polarisation angles for all satellites based on
your location
• Stores information on 100 of the most popular satellites worldwide
• LNB short circuit protection built-in
• Includes magnetic compass to assist alignment
• 7.4V/800mAh rechargeable Li-Ion battery and mains power charger included
• Easy to carry with protective sleeve and shoulder strap
• Software upgrades possible from a PC using the USB port and cable supplied
4 Product Overview
S201 - Introduction and Features
No Description
1
Power Switch
2
LNB IN
3
LCD Screen
4
Micro USB Port
5
DC Socket
6
Digital display
7
Power
8
22KHZ
9
13V
10
18V
11
LOCK
12
Charger
13
OK
14
Return
15
t
16
q
17
u
18
p
19
20
Compass
21
Torch
22
Cover
Function
Turn meter on/off
Connect to satellite down lead
Colour display
Connects to PC for software updates
Connects to charger
Shows signal quality
Power indicator light
22Khz indicator light
Vertical polarization voltage output light
Horizontal polarization voltage output light
Signal lock indicator light
Charging LED indicator
OK key
Return key
Left key
Down key
Right key
Up key
Torch Switch
Magnetic compass
LED light
Battery compartment
3
Advertisement
Table of Contents
Need help?
Do you have a question about the S201 and is the answer not in the manual?
Questions and answers
why has my s201 meter stopped showng sinal quality
Your Labgear S201 meter may have stopped showing signal quality due to several possible reasons:
1. Weak or No Signal – Ensure the satellite dish is correctly aligned, and the LNB is functioning properly.
2. LNB Short Circuit Protection Activated – If there is a short circuit in the LNB connection, the meter may disable signal detection. Check the cable and connections.
3. Incorrect Satellite Selection – Verify that the meter is set to the correct satellite and transponder.
4. DiSEqC or 22kHz Tone Settings – Ensure these settings match your satellite system requirements.
5. Low Battery – If the battery is low, recharge it using the provided charger.
6. Software Issue – Try updating the meter’s software using the USB port and supplied cable.
Check these factors, and if the issue persists, inspect the device for faults or consider resetting it.
This answer is automatically generated