QUICK GUIDE Contents Uponor Smatrix Wave components Uponor Smatrix Wave components ......2 An Uponor Smatrix Wave system may be a combination System example ..............2 of the following components: Safety instructions ............3 Uponor Smatrix Wave X-165 (controller) Controller ................3 Thermostat/System device ..........3 Uponor Smatrix A-1XX (transformer A-1XX) Thermostatic Head ............3...
Controller be done before registering a system device. N O T E ! arning The Uponor system uses 50 Hz, 230 V AC Up to four controllers can be registered to an power. In case of emergency, immediately interface. disconnect the power.
QUICK GUIDE Quick Guide Installation 8. Insert batteries into the thermostats. 9. Select thermostat control mode (settings menu 04, 1. Attach the full assembly, or parts of it, to the wall in digital thermostats only). Default: RT (standard either with a DIN rail or by using wall screws and room thermostat).
Page 6
QUICK GUIDE T-169 T-168 T-166 T-165 T-163 T-161 12.1 12.2 12.3 12.1 T-161 T-169 T-163 T-166 T-168 T-165 12.1 I-167 15.1 15.2 T-163 M-161 15.3 15.4 I-167 M-161 T-163 16.2 16.1 Français Svenska Italiano Deutsch English Português Suomi Español Link Touch Screen to controller 16.3 Link OK 16.1...
QUICK GUIDE Register thermostat and/or system device 15.1 Use buttons < or > to move the pointer to the power LED (LED flashes red). to a controller 15.2 Press the OK button to enter system channel To register room thermostats and system devices (interface registration mode.
A maximum of two thermostatic heads can be registered per channel. See section Uponor Smatrix Wave documentation for more information. 2. Press and hold the OK button on the controller until the LED for the first unregistered channel flashes red.
QUICK GUIDE Register thermostatic heads to controller To register thermostatic heads in the controller: in rooms without a thermostat 1. Press and hold the OK button on the controller until the LED for the first unregistered channel flashes red. If all channels are registered to thermostats, the LED flashes red and green.
QUICK GUIDE Register multiple controllers Unregister all channels Up to four controllers can be registered to an interface. When one or more channels (thermostats and system devices) are inaccurately registered, it is possible to All additional controllers in the system must be remove all registrations at the same time.
QUICK GUIDE Technical data General IP20 (IP: degree of inaccessibility to active parts of the product and degree of water) Max. ambient RH (relative humidity) 85% at 20 °C Interface CE marking Low voltage tests EN 60730-1 and EN 60730-2-1 EMC (electromagnetic compatibility requirements) tests EN 60730-1 Power supply...
Page 12
QUICK GUIDE Thermostatic head T-162 IP20 (IP: degree of inaccessibility to active parts of the product and degree of water) Max. ambient RH (relative humidity) 85% at 20 °C CE marking ERP (thermostat only) Low voltage tests EN 60730-1* and EN 60730-2-9*** EMC (electromagnetic compatibility requirements) tests EN 60730-1 and EN 301-489-3 ERM (electromagnetic compatibility and radio spectrum matters) tests...
Page 13
QUICK GUIDE U P O N O R S M AT R I X WAV E · Q U I C K G U I D E...
Page 14
Uponor Corporation www.uponor.com Uponor reserves the right to make changes, without prior notification, to the specification of incorporated components in line with its policy of continuous improvement and development.
Need help?
Do you have a question about the Smatrix Wave X-165 and is the answer not in the manual?
Questions and answers