Table of Contents
Advertisement
By using the PJP-25URS Controller, you can adjust the unit's settings which cannot be controlled with key operations.
Basic operations of the PJP-25URS
Controller
This section explains about the basic operations of the
PJP-25URS Controller.
1
Connect this unit to the PC using the
supplied USB cable.
The icon in the task tray (the lower right screen)
changes to
.
Notes
• You cannot connect multiple microphone speakers including
this unit to one PC and use them simultaneously.
• When
appears in the task tray, you cannot access Skype
from the PJP-25URS Controller. To use this unit with Skype,
permit access from the PJP-25URS Controller on Skype.
y
• In the case that
is not displayed when this unit is
connected to the PC, select [Start] - [All Programs] -
[Yamaha PJP-25URS] - [PJP-25URS Controller] to
start the PJP-25URS Controller.
• To start the PJP-25URS Controller on PC start-up,
click
and then select "Start PJP-25URS Controller
on PC start-up".
2
In the task tray, click
PJP-25URS Controller".
The "PJP-25URS Controller" screen appears.
y
You can also open or close the PJP-25URS Controller by
pressing both VOLUME +/- keys at the same time.
3
Configure the settings.
Configure the settings of this unit according to the
use environment, following the instructions described
at "About the "PJP-25URS Controller" screen"
(page 14).
Using the PJP-25URS Controller
and then select "View
To quit the PJP-25URS Controller
Follow the procedure below to quit the PJP-25URS
Controller.
1
Click
at the top right corner of the "PJP-
25URS Controller" screen.
The "PJP-25URS Controller" screen closes.
2
Right-click
in the task tray, and then select
"Exit".
The PJP-25URS Controller exits.
13
Advertisement
Table of Contents
