Smith Corona Freedom II User Manual

@f Lj
U t
,l*.*ooo,,o*
BASE Unit HEADSET&HEADBAND
-:.
g)
J
{\)
EAR-HOOK
TELEpHONE CONNECTTON CORD
USB CABLE
(Optional)
1. Can not hear a dial tone.
F
Check the TEL/PC button.
TEL lvlote: PCITEL indicator -
'OFF'
6
Please check the cable connection between Base unit and Phone.
F Check that the power adapter is plugged in and has power
,-
Please check the compatibiiity switch. Adjust compatibility switch until
you can hear the dial tone
2. Microphone volume (TX) is low / dead.
* [/ake sure that the microphone (TX) mute function is deactivated.
e Check the position of the boom arm and make sure that the microphone
is placed as close as possible to your mouth (approx. 2 fingers
d i s t a n c e ) .
F Adjust the microphone (TX) volume on the bottom of base unit.
3. Buzzing sound on the headset
@ Telephone may not be fully immune to the radio transmission between
your headset and base. To overcome this problem, move the base unit
t o a t l e a s t 3 0 c m l 1 2 " a w a y f r o m t h e p h o n e .
4. Headset echoes
* A d j u s t t h e t e l e p h o n e ' s v o l u m e . l f n e c e s s a r y , a d j u s t y o u r m i c r o p h o n e
volume on the headset to a lower setting.
5. EHS doesn't work with the telephone
,-
Make sure the telephone is compatible with the wireless headset. Flefer
t o t h e E H S g u i d e .
6. Headset was working, but it has stopped.
, .
H e a d s e t m a y n e e d p a i r i n g t o t h e b a s e a g a i n . R e f e r t o t h e ' N o t e 1 ' o n
'Operational
Instruction'
-
Headset battery may be dead. Return the headset to the cradle on the
base unit for charging.
Speaker Volume Up/Down
Microphone Mute (Press)
Plug the Powor Adapter cord on the Base unit.(Note 1 )
Press Hook On/Ofi switch to make a call
Select compatibility switch '1' or '2' position until you can hear the dial tone
Adjust speaker and microphone volume
Press Hook On/Off switch to end a call
Note 1 : Factory default setup : Paired
Pairing process is automatically proceeding when plug the power adapter into the
Base Unit. (Make sure that headset is placed on the cradle before power is turned on. lf
the headset is not placed on the cradle, pairing will be unsuccessful.)
The unit enables you to answer and end calls remotely by using its built-in electronic
hook switch (EHS). EHS of this unit is only compatible with certain telephone systems
supporting EHS.
*
EHS is only compatible with certain telephone systems. In order to determine
which telephones are compatible with the EHS feature, please refer to EHS
guide or conlact your local distributor Please also refer to your telephone's
user manual for clarification.
Base ToD
loW
@____J
@EU
m
Connect telephone cord to the headset porl or handset port of a
teleDhone / base unit