TP-Link TL-WPA7510 KIT Quick Installation Manual

Quick Installation Guide
TL-WPA7510 KIT
* TL-WPA7510 KIT (European version) is
used for demonstration in this QIG.
e
r l i n
w e
P o
LAN
Router
Extender
TL-WPA7510
ps
Mb
10 00
2
Adapter
TL-PA7010
Plug in the adapter and extender in the
same room. Wait for about 30 seconds
until the extender's 2.4GHz and 5GHz
Wi-Fi LEDs
Note: If only one wall outlet is available, plug both
devices into a power strip for setup, then relocate
to wall outlets before enjoying the internet.
1
3
Pair the powerline devices.
A
Press the adapter's Pair button for 1 second.
The Power LED
Note: If the LED does not blink, press the
button again.
On
b p s
0 M
1 0 0
Adapter TL-PA7010
4
Relocate the extender to the Wi-Fi "dead" zone on the same electrical circuit. Connect your devices
to the internet using the default SSID (network name) and password on the Wi-Fi Info Card provided.
Note: If the Powerline LED turns red, it means the signal strength is poor. Try another wall outlet.
turn on.
Attention
Plug powerline devices into wall outlets. Do not use power strips after setup.
Wall Outlet
B
Within 2 minutes, press the extender's Pair button for 1 second.
starts blinking. The Power LED
When the Powerline LED
complete.
Blinking
Within 2 minutes
10 00
M bp
10 00
Mb ps
Extender TL-WPA7510
Tips:
Want to unify Wi-Fi networks or
personalize your network?
See the back page for instructions.
Power Strip
starts blinking.
turns on, the pairing process is
Blinking
On
s