Kaba PowerPlex 2000 Series Quick Reference Manual

Summary of Pushbutton Programming Commands
Name Command
Diagnostic
500 #
123456789*0#
Visual Feedback Message Definitions
Condition
Green LED
Valid pushbutton ON
pressed
Timeout expired OFF
Valid access ON
code keyed
Access granted ON
Access granted ON
(battery low condition)
Access denied OFF
Valid programming ON
entry
Invalid programming OFF
entry (including
duplicate access code)
Tamper shutdown OFF
beginning
Tamper shutdown state OFF
Tamper shutdown ON
ending
For PowerPlex 2000 only:
Lock is ready when front ON
lever is depressed
Lock's stored power is OFF
starting to fade
A = 1/10 second; B = Twice; C = Can be observed only when you pump the lock's lever
www.kabaaccess.com
Description of Command
'Manual diagnostic'
Parameters
Red LED Duration
OFF 1/10 sec
ON 1 sec; A
OFF 1 sec
OFF 1/10 sec
ON 1/10 sec
ON 1 sec; A
OFF 1 sec
ON 1 sec; A
ON 2 sec
ON 1 sec; C
OFF 2 sec; C
OFF 1/10 sec
ON 1/10 sec
PKG3172 0313
E2000 Operation: Enter your valid PIN to Access the lock and/or to program the
Rate
lock at its keypad.
Once
PowerPlex 2000 Operation: This model is a self-powered lock. To access and/or
Once
program the lock, you must first generate power by depressing the front lock
Once
lever down at least once. This energizes the lock temporarily for a few seconds ,
enough time for you to enter your PIN and open the lock, or start to program the
1 sec
lock with a command sequence.
1 sec
To begin, put lock in programming mode by pressing: #Master Code#
Once; B
Summary of Pushbutton Programming Commands
Once
Name
Once; B
Configur
Once
10 sec
Once
Once
1 sec
2000 Series
Series
Command Description of Command
000 # 'Modify Master User Access Code (lock's
activation)' (Always 8 digits)
MMMMMMMM#
MMMMMMMM#
004 # 'Unlock time setup' (TT = 02 to 20 seconds)
TT#
'Passage Mode Timeout setup' (TT = 01 to 24
005 #
hours - duration time in hours; 00 = no time limit)
TT#
Note: Not applicable to PowerPlex 2000 models
006 #
'Tamper time setup' (TT = 00 to 90 seconds)
TT#
007 #
'Tamper wrong try setup' (TT = 03 to 09)
TT#
008 # 'Buzzer volume control' (VV = 00 to 03; 00 = off;
01 = Low; 02 = Normal; 03 = High)
VV#
009 # 'Modify access length' (LL = 04 to 08 digits)
LL#
099 #
'Reset to factory default values', except access
code length. (Master, manager and access user
are retained if already programmed.)
Quick
Reference
Guide