Seametrics FT430 Quick Start Manual

The Home Screen

0.00
The left/right keys are used to move through the menus and position the cursor during data entry. The up arrow is
used to scroll through the available values that are to be entered. For example, numerical values for K factor entry or
selection of units from the available options. The enter key (represented on the keypad by the check mark) is used to
save selected entries and in conjunction with the exit tab to move between menus screens. As one
navigates the menus, the current parameter setting is shown and instructions are displayed for how to change the
selected parameter.
Set K Factor ( SET K )
SET K R UNIT T UNIT
086238.235
PRESS TO SET NUMBER
OF PULSES RECEIVED PER
GALLON OF FLOW
SET P RESET
Set Rate Display ( R UNIT )
SET K R UNIT T UNIT
FLOW RATE = GPD
PRESS TO SET UNITS
FOR DISPLAY
SET P RESET
253.872.0284
The Home screen displays total flow volume and flow rate. The four buttons below
GPD
the LCD display are used to access menu screens for viewing and changing setup
parameters.
0
MID
The K factor is the number of pulses the flow
SET D
sensor provides to the FT430/440/450 for every
gallon of flow. (Note that the decimal is fixed at
three places. If you only have two decimal places
for your K-factor, enter a zero for the third digit.
If unable to set K-factor, the unit is "locked"
EXIT
to prevent tampering. Please contact your
distributor for assistance.)
View or change the flow rate display units.
SET D
EXIT
Press the check mark key to enter a submenu.
Page 1 of 2
FT430/440/450
Quick Start Guide
SET K R UNIT T UNIT
086238.235
PRESS AND TO CHANGE
AND TO EXIT
SET P RESET
SET K R UNIT T UNIT
RATE: GALLONS / MIN
PRESS AND TO CHANGE
SET P RESET
SET D
EXIT
SET D
EXIT
seametrics.com