Security; Rds Terminal Commands - Orban OPTIMOD-FM 8700i Operating Manual

2-94
INSTALLATION

Security

RDS Terminal Commands

AF 20=0
AF 21=0
AF 22=0
AF 23=0
AF 24=0
In the System I/O RDS control screen, you can set the RDS Terminal control security
by specifying an RDS IP address from which to accept commands. Once set, this IP
will be the only IP that can connect to the unit to update RDS. The 8700i will default
to 0.0.0.0, which will allow any IP to connect to the RDS terminal control.
To prevent the Optimod from disconnecting and being unable to reconnect if the
terminal connection drops out temporarily, set the TIMEOUT value (as shown in Ta-
ble 2-1) to the maximum expected duration of the dropout (in minutes). Default is 4
minutes. Note that the timeout reverts to the default each new connection; if you
change the timeout for one connection, it is not retained for the next one.
Table 2-2 lists the terminal commands.
Note that you can fetch the status of the RDS generator as follows:
[command] ? returns current value
ST returns current value of all controls
HELP returns a list of the RDS terminal commands
 = CR/LF
in Table 2-2
COMMAND PARAMETER
PS= / DPS= Dynamic PS
DPSS=
DPS Dynamic
Program Service
Speed
DPST=
DPS Dynamic
Program Timeout
RT= Radio Text
INFORMATION
256 (max) characters for scrolling
messages in the PS field
OFF = Default PS Option Disa-
bled
2 - 9 = wait time in seconds be-
tween receipt of last incoming
DPS and transmission of DPS De-
fault. Default is the DPS control
value as designated in the I/O
Setup.
0 = Default PS Option Disabled
1 - 7 = wait time in minutes be-
tween receipt of last incoming
DPS and transmission of DPS De-
fault. Default is the DPS control
value as designated in the I/O
Setup.
128 (max) character message to
be displayed by the
receiver if so equipped
ORBAN MODEL 8700i
EXAMPLE
DPS=Artist Goes Here
:: Title Goes Here
DPSS = 2
DPSTIMEOUT=0
RT=KRD
:: (800) 111-1111
:: www.domain.com