Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Tunstall The Vibby
Summary of Contents for Tunstall The Vibby
- Page 1 Life Changing, Life Saving The Vibby User and Installation Guide...
-
Page 2: Table Of Contents
Manual alarm cancellation Protocol which enables it to work with the Tunstall Smart Hub. Wearer Mode configuration The Vibby is also IP67 (dust and water resistance) and IK4 & IEC 62599-1 2010 Class2 (shock and impact). Checking wearing mode configuration... -
Page 3: Getting Started
Once in Active Mode, please put your Vibby on as it is ready to The Vibby is shipped in Storage Mode, it is important to exit use. The Vibby can raise alarms in two ways; manual calls - when Storage Mode by following the instructions below. -
Page 4: Types Of Falls
1. Fasten the wrist strap or neck cord and hold the Vibby at a minimum of 70cm above the ground. If configured for Wrist... -
Page 5: Automatic Alarm Cancellation
LED. If during step 3, the user does not remove their hand after the first burst of vibrations, the Vibby will vibrate three times to indicate that the alarm has not been cancelled. This is an in- built safety feature that is designed to ensure the alarm is not... -
Page 6: Wearer Mode Configuration
Wearer Mode configuration Wearer Mode configuration (contd.) If you wish to change the way in which you wear the Vibby i.e. either from Wrist Strap Mode to Neck Cord Mode or vice versa, it first needs to revert back into Storage Mode before any To confirm the Vibby is in Storage Mode, press recogfiguration can occur. - Page 7 Please be aware your thumb could be over the green LED and it LED lights steadily and may be difficult to detect. then turns off. Once the Wearer Mode has been set the Vibby will return to Storage Mode.
-
Page 8: Checking Wearing Mode Configuration
Checking Wearer Mode configuration Removing the wrist strap It is possible to check the Wearer Mode the Vibby is configured to by following these steps while the Vibby is in Storage Mode. The Vibby comes pre-packed with a wrist strap. Follow the below steps to remove the Quickly press the button twice. -
Page 9: Fitting A Replacement Wrist Strap
Fitting a replacement wrist strap Fitting a neck cord to the Vibby Please ensure that the neck cord is attached with the Take the Vibby and place it correct orientation to the within the wrist strap. Vibby. You will notice on the back that there is more white space on the bottom edge. -
Page 10: Ensuring The Wrist Strap In Correctly Installed
Ensuring the wrist strap in correctly installed Exiting from Storage Mode The Vibby will now need to revert to Active Mode to be ready for use. To do this, follow the instructions below. Press and hold the button. Retention features Release the button when the red LED starts flashing. -
Page 11: Battery Replacement
Battery replacement Battery replacement (cont.) To replace the battery in the Vibby; use the battery change tool (Part No D6656001A) and follow the steps below. Replace the existing o-ring (D6654020A) with a new o-ring. Ensure the Vibby is in Storage Mode before removing the battery (page 10). -
Page 12: Cleaning
Technical details Warnings and cautions Dimensions (W x H x D) 34mm x 37mm x 13mm It is important to test the Vibby in all areas of the home, including Weight the bathroom, basement and garage. Environmental conditions Battery type... - Page 13 Life Changing, Life Saving tunstallhealthcare.com.au Our policy of continual development means that product specifications and appearance may change without notice. Tunstall does not accept any responsibility for any errors and omissions contained within this document. © 2016 Tunstall Group Ltd.
Need help?
Do you have a question about the The Vibby and is the answer not in the manual?
Questions and answers