Kenwood TS-890S Command Reference Manual page 71

LAN EXCLUSIVE COMMAND TABLES
##CN
LAN Connection Request
1 2 3
Read
# # C
1 2 3
Answer
# # C
##DD2
Bandscope Display Information (LAN Output Only)
1 2 3
Answer
# # D
##DD3
Filter Scope Display Information (LAN Output Only)
1 2 3
Answer
# # D
PC Control Command referenCe guide
4 5 6 7 8
N ;
4 5 6 7 8
N P1 ;
4 5 6 ~ 1285 1286
D 2 P1 ;
4 5 6 ~ 431 432
D 3 P1 ;
Parameters:
P1
9 10
0: Connection Denied
1: Connection Authorized
9 10
• If a LAN connection already exists, performing this command
will result in a connection denial.
Parameters:
P1 (Bandscope spectrum display information (1280 digits))
640 spectrum information are each expressed as 2 ASCII digits.
Two digits at the beginning are spectrum information of the left
side, and two digits at the end become the spectrum information
of the right side.
When EXPAND (spectrum analysis range enlargement) is
ON, display information in the range enlarged than the range
displayed on the transceiver is output.
Example:
• When the display span is 100 kHz, spectral display
information in the range enlarged to 300 kHz is output.
• When the display span is 200 kHz, spectral display
information in the range enlarged to 400 kHz is output.
The range of value for each spectrum information is from 00h ~
8Ch (hexadecimal numbering).
00h shows the state where the spectrum is extended to the
top (signal strength = 0 dB) and 8Ch shows a state where the
spectrum is not displayed (signal strength = -100 dB).
The respective spectrum information is converted to ASCII code
of the hexadecimal number of from the upper byte digits. For
8Ch, the order becomes "8", "C".
• When the AI function is ON, the data is output at a constant
period by the LAN terminal when the DD0 command is set to
"Output to LAN (high frequency)", "Output to LAN (medium
frequency)", or "Output to LAN (low frequency)".
Parameters:
P1 (Spectrum Display Information (426 digits))
213 spectrum information are each expressed as 2 ASCII digits.
Two digits at the beginning are spectrum information of the left
side, and two digits at the end become the spectrum information
of the right side.
The range of value for each spectrum information is from 00h ~
32h (hexadecimal numbering).
00h shows the state where the spectrum is extended to the
top (signal strength = 0 dB) and 32h shows a state where the
spectrum is not displayed (signal strength = -50 dB).
The respective spectrum information is converted to ASCII code
of the hexadecimal number of from the upper byte digits. For
32h, the order becomes "3", "2".
• When the AI function is ON, the data is output at a constant
period by the LAN terminal when the DD1 command is set to
"Output to LAN".
• When the transceiver is displaying the audio scope, it is not
output.
– 70 –