CONTENTS FIRING Single Set Point Firing Firing the SPPROG Program Firing the SPRAMP Program 2000 INSTALLING THE PORTABLE P How to Stop the Furnace While Firing SPPROG or SPRAMP How to Tell if There Was a Power Failure & TERMS FEATURES REFERENCE USING THE KEYS...
INSTALLING THE PORTABLE P 2000 Carefully inspect your controller as soon as it arrives. If it is damaged, call your dealer. Then notify the freight agent at once and request an inspection. Save all pack ing materials for inspection by the freight claims ad juster.
TERMS FEA TiJRES & Summary of Keys Func RESET is used in a tion Switch display. It will c a ncel a new adjustment. This is useful you make a FUNC brings the Func mistake with the arrow keys. tion Switches into display. This key works only when a Set-Up Mode is displayed.
USING THE KEYS Soak soak is a stage of firing where the temperature is held steady for a certain length of time. There are two Set Up Modes adjustments for each soak: time and temperature. SPRAMP: Set Point with Ramp SPRAMP firing, one Sf T of three ways to fire with the controller, is a single-ra�p SE T...
DISPLAY MESSAGES Exercise Your controller temperature display is in DISPLAY MESSAGES HOLD normal temperature mode. (Note: If appear in the display window alternating with a temperature, skip this exercise until later.) Turn off the on/off switch for the elements so that the furnace will not begin firing.
FIRING and six soaks. The SPPROG program is the heart of the controller. When the controller is not firing a program, it is The third method· is with the SPRAMP program. running in Single Set Point. You can set the Single Set SPRAMP is a single-ramp program.
Page 9
FIRING The display now reads If you use rate as a ramp unit, the bottom display ENAb:SPROG. during firing will not show time left in a ramp P ress FUNC key. STRSEG will ap 11.30). (example, Instead it will show degrees per minute (IIO-segment 1, 10 degrees per minute).
FIRING your furnace to begin firing at a.m. When you arrive Press FUNC again to get in your studio, your furnace will have only one hour to FINLSP (final set point). Use ,nnnF go before the firing is completed. the arrow keys to enter the IUUU temperature you are firing to.
REFERENCE In the event of a power failure, the furnace will fire at the Single Set Point that you set before starting the firing program. See "Single Set Point Firing" to adjust the Single Set Point. Trouble Shooter KEYERR WHEN YOU PRESS RUN/HOLD REFERENCE Both firing schedule s-the 12-segment SPPROG and the single-ramp SPRAMP-are...
Page 12
Ram p/Soak Worksheet 2400 2200 2100 2000 1 900 1700 1000 1 500 1400 l2JO 1 100 - L- '- 100 0 � g)() :::» � HOURS Function Seg- Enter This Function Seg- Enter This Display Function Seg- Enter This Display Display ment...