Table of Contents
Advertisement
RIBBON REPLACEMENT
(See diagram on opposite page)
To replace the ribbon, open the front cover and loosen the Lock knob on the left side of the
print head(s). Note setting on the Penetration Control knob, then set knob to No.5. In the
Model 102A, repeat this for both print heads. Open side covers. Remove caps from ribbon
reversing guides. Swing ribbon tension arms clear of spools. Lift spools from axles. Place empty
spool (partially wound) on right-hand axle. Insert ribbon through right-hand reversing guide and
thread through idlers and ribbon guides. Place full spool on left-hand axle, assuring that ribbon is
inserted in left-hand ribbon reversing guide. Replace ribbon reversing guide caps. Close side
covers. Readjust Penetration Controi knob to originai setting and iock. in Modei 102A, readjust
Penetration Control knob for both heads.
RIBBON SPECIFICATIONS
The printer uses a 1-inch nylon ribbon mounted on 3-inch diameter spools. The following
four colors are available:
Black
Red
Green
Blue
Part No. 63002293-01
Part No. 63002293-02
Part No. 63002293-03
Part No. 63002293-04
PAPER SPECIFICATIONS
The printer uses continuous form paper with standard feed holes on each edge. Paper widths
from 4 to 14-7/8 inches can be accommodated by the printer. Using multiple-part form, one
original and up to 4 copies can be printed, all very legible. Paper weight specifications are as
follows:
Single-Part Forms:
Multiple-Part Forms:
Carbon Paper:
15 to 20 Ib
Original - 12 to 15 Ib
Copies - 9 to 12 Ib, last copy 15 Ib
(Maximum of five parts)
7-1/4 Ib with medium hardness
10
Advertisement
Table of Contents
