Preparing for Installation
Overview
Before you begin, make sure that the module is in good condition and that you have
the tools and equipment listed here.
Unpacking and Inspecting the Module
As you unpack the module, inspect it for shipping damage. If you find any damage,
contact Cisco. Refer to Chapter 6 for information on contacting Cisco Services.
Equipment and Tools Needed
Before you begin, make sure that the module is in good condition. You need the
following equipment and tools to install these modules.
You need . . .
a Prisma II Chassis with power supply
3/8-in. flat-blade screwdriver
RF cable with connectors
2-2
To . . .
provide housing, power and
input/output connections to the module
secure the module in the chassis
carry RF signals
Installation
78-4006323-01 Rev C