Verifying And Changing Ip Addresses - MELAG Vacuklav 41 B+ Technical Manual

Connecting the steam sterilizer to a network
Manually configured
Automatically configured
network (DHCP)
Device
Steam sterilizer itself
Computer
Log printer
Label printer
Gateway
Subnetwork mask
Table 1: IP addresses saved in the steam sterilizer
Warning!
12
If the network is manually configured, then the subnetwork mask of the
network medical practice network must be known. If a subnetwork mask is used other
than the one preset in the steam sterilizer, a software expert should adapt the
IP addresses in the steam sterilizer. If the masks conform and the above-
mentioned IP addresses are not assigned, then a log printer or label printer
can be connected directly to the steam sterilizer.
The network is automatically configured in a dynamic network.
In this case, in the Settings  Logging menu set the IP address of
▪
the steam sterilizer on DHCP.
If logging takes place over a computer via FTP, then a fixed IP address must
be determined for the computer, which is then registered in the steam
sterilizer.
NOTICE!
If a DHCP server cannot be located in the practice network, the steam
sterilizer will automatically recieve the pre-set static IP address.
The IP addresses for the following devices are saved in the steam sterilizer
as parameters:
IP address
192.168.40.40
192.168.40.140
192.168.40.240
192.168.40.160
192.168.40.244
255.255.255.0
■ The input of false IP addresses can lead to disturbance of the
practice network.

Verifying and changing IP addresses

The IP addresses are changed in the Settings  Logging menu.
▪ Follow the logging assistance until you reach the window in which the IP
addresses for the specific devices are listed.
▪ Select, for example, the steam sterilizer. It opens the next window.
▪ Select the numeric keypad which you wish to change directly by
choosing each respective number.
▪ Delete the digits with the C button, then enter a new number and
confirm with SAVE.
▪ Proceed in the same way with the other devices that are to be
connected to the network.
Comment
Default setting ex factory
Default setting ex factory
Default setting ex factory
Default setting ex factory
Not relevant within a network
Possibly take over from the customer network