Enabling Or Disabling Snapshot - Hitachi AMS2100 User Manual

Enabling or disabling SnapShot

Hitachi AMS 2000 Family Copy-on-Write SnapShot User Guide
Once SnapShot is installed, it can be enabled or disabled.
In order to disable SnapShot, all SnapShot pairs must be released
(the status of all LUs are Simplex).
To enable or disable SnapShot without rebooting
(For instructions using CLI, see
page B-7.)
1. In the Navigator 2 GUI, select the array where you want to enable
SnapShot, and click Show & Configure Array.
2. In the tree view, click Settings, then click Licenses.
3. Select SNAPSHOT in the Licenses list, then click Change
Status.
The Change License screen appears.
•
4. To enable, check the Enable: Yes box.
To disable, clear the Enable: Yes box.
5. Click OK.
•
•
6. In the confirmation screen that appears for the enabling and
disabling actions, click OK.
7. A message appears confirming that this optional feature is set.
Click Reconfigure Memory.
•
The Licenses list appears.
8. Confirm Pending on the Reconfigure Memory Status column.
Installing and enabling SnapShot
Enabling or disabling SnapShot on
4-11