Rd4000 Receiver Information Codes - Radiodetection RD4000T3F User Manual

RD4000 receiver information codes

The RD4000 incorporates several information codes that are
displayed to show that a requested operation can not be
performed. The information screen will be displayed for
approximately five seconds and clear. The codes and their
meanings are:
Code
02
05
07
010
011
013
RD4000 Locating System User Manual
Meaning
On switch-on, the receiver could not restore the previous settings. This means
that when the receiver is switched on it will switch on in its default settings rather
than those in which it was last switched off.
This is not critical, as the receiver will function normally in all other respects.
During a depth reading the top antenna signal is greater than the bottom
antenna. The receiver may be under overhead power cables.
Take a depth reading in another location.
While computing the depth a signal has caused one or both antennas to 'clip'
thus invalidating the depth reading.
Repeat the measurement.
An accessory that is not supported by the current receiver software has been
connected to the receiver.
The receiver requires a software update before the accessory can be used.
Some 'intelligent' accessories have an identification code that tells the receiver
the type of accessory that is connected to the receiver. Code 011 indicates that
the identification code has been lost. Re-try the connection. If this is
unsuccessful, the accessory needs re-programming.
A CD reset has been attempted but there is no valid CD signal.
Try to reset again. If unsuccessful, ensure the transmitter connections are the
correct way round.
Radiodetection
Part No: 01.02
RD4000 RD4000
mA mA
Page 45