Woodpeckers Coping sled Assembly And Use Instructions

Woodpeckers
Assembly
Made in USA.
STEP 1. Installing the Fence.
(5) ⁄ " Flat head screws. (5) Oval nuts.
5
8
Insert the screws up through the bottom of the base and
loosely start the oval nuts. Slide on the fence with the single
track side facing down.
COPING SLED
(2) Registration pins.
(1) 16" Fence.
Insert the two registration
pins behind the fence.
Align the fence flush with
the right edge of the base
and pull it back against the
pins. Firmly tighten the five
screws and Remove the
pins.
Assembly and Use
Instructions.
STEP 2. Installing the Top Plate Screws.
(2) 1 ⁄ " Flat head screws. (2) Thick, gold,
1
2
washers.
(2) Nuts with
star washer.
Insert two screws up through the bottom of the base. Slip on
one of the thick washers and thread on a nut. The star wash-
er side of the nut needs to face the thick gold washer. Firmly
tighten each screw.
STEP 3. Installing the Spacer Tubes.
(4) 2 ⁄ " Flat head screws.
1
2
Loosely assemble each 2
into each of the four holes as shown. The screws are inserted
from the bottom. Do not tighten. Leave an approximate
between the top of the tube and the bottom of the oval nut.
(5) Oval nuts. (4) Spacers tubes.
⁄ " screw, spacer tube and oval nut
1
2
⁄ " gap
1
8