Pair A Bt Remote To Your Awning; Pair A Bt Motion Sensor To Your Awning - Carefree BT12 User Manual

U ' G
SER S UIDE
3.2.3 P A BT R
AIR EMOTE
1. Ensure the physical power switch is turned ON prior to pairing your BT Remote, and that you are
attempting to pair within the 5 minute open pairing window.
2. Position your BT Remote as close to the BT Control Module as possible.
3. It may take several seconds for the device to pair, but you can verify that pairing was successful by
pressing the extend button on the remote. The awning should extend following the command.
You can verify the pairing by opening the Carefree Connects Mobile App and navigating to the
Peripherals page. The remote will be listed under "Device Status" (refer to page 13).
4. Once paired, the awning will remember the BT Remote for future use.
Battery replacement is covered in the owner's manual for your awning equipped with the BT12 Wireless
Awning Control System. Owner's manuals are available at www.carefreeofcolorado.com.
3.2.4 P A BT M
AIR OTION
NOTES:

Only 1 active motion sensor can be paired to the BT12 Control Module.

Depending on the awning type, the BT Motion Sensor may or may not be visible on the outside of the
product. You can use the mobile app to easily identify if you have the BT Motion Sensor. If the motion
sensitivity slider on the settings page is not grayed out, then you have the BT Motion Sensor.
Location of the motion sensor is shown in the owner's manual for your awning equipped with the BT12
Wireless Awning Control System. Owner's manuals are available at www.carefreeofcolorado.com.
1. If not previously done, remove the motion sensor from the mounting bracket.
2. Turn the power switch to ON and extend the awning using the switches.
3. Place the awning in pairing mode (refer to page 4).
4. Remove the battery pull tab from the motion sensor.
5. Hold the motion sensor next to the control module for 2-3 seconds. The module should be paired.
6. To test, hold the sensor vertically with the Carefree logo upright, repeatedly move the sensor vertically
up and down to simulate a brisk wind. The awning should retract.
You can verify the pairing by opening the Carefree Connects Mobile App and navigating to the
Peripherals page. The motion sensor will be listed under "Device Status" (refer to page 13).
7. Snap the module in the sensor bracket.
Battery replacement is covered in the owner's manual for your awning equipped with the BT12 Wireless
Awning Control System. Owner's manuals are available at www.carefreeofcolorado.com.
Getting Started
T Y A
O OUR WNING
S T Y A
ENSOR O OUR WNING
6
C C M
AREFREE ONNECTS
A
OBILE PP