Configuration Using Kpg-89D - Kenwood TK-2180 Modification Information

3.2.4 Configuration using KPG-89D

You can configure the ANI board information into the
transceiver using KPG-89D after installing the board.
Follow the procedures below to configure the ANI board
information into the transceiver.
1. Run the KPG-89D.
2. Select
"Program" > "Read Data from the Transceiver"
You can also click the
The Read Data from the Transceiver window appears.
3. Click "Read".
The KPG-89D starts reading the configuration data
from the transceiver.
4. Select
"Edit" > "Extended Function"
The Extended Function window appears.
TK-2180/ 3180 Transceivers
TK-7180/ 8180 Transceivers
5. Select "ANI Board" from the External Device pull-
down menu.
Note: Refer to the instruction manual supplied with the ANI
Board for configuration of the ANI Board.
6. Select signal as Channel busy of QE-2 from OPT1
pull-down menu.
When QE-2 board selects "Trunking" for transmit
mode via QE-2 E2 programming software, it should be
selected LOK., which is signal LTR link is success and
possible to start talking. After this signal changes to
Low, PTT ID and Emergency message will be
Version: 1.13 USA
icon on the Toolbar.
.
Modification Information
3 CONNECT THIRD PARTY OPTIONS
transmitted. Otherwise, selecting "Conventional" for
transmit mode, it should be choose COR or TOR,
which is signal the radio is receiving signal and open
squelch. During receiving that signal, QE-2 board
handles to not start Emergency, Man-Down or PTT ID
transmission.
7. Select PTT ID type on Optional Feature window.
"Edit > Optional Feature > Common-Page 3".
.
8. Configure PTT ID sending channel/GID for each.
"Edit > Zone Information > Channel/GID Edit"
Note; Even if each channel are already selecting PTT ID "On"
for FleetSync PTT ID before selecting PTT ID type to
"ANI Board", it will be reset to off when you select ANI
Board for PTT ID type or Optional board selecting.
Please confirm it before writing data into the radio.
9. Configure Emergency ID on Emergency Information.
"Edit > Emergency Information > Emergency ID"
All Emergency transmitting and receiving are handled
by QE-2 board. Configure the board for Emergency
setup.
10. Select
"Program" > "Write Data to the Transceiver".
You can also click the
The Write Data to the Transceiver window appears.
11. Click "Write".
The configuration data having the ANI board
information will be written to the transceiver.
icon on the Toolbar.
38