Texecom Premier Elite Impaq Plus-W Instruction Manual page 2

Battery
Only replace with 3V Lithium CR123A.
Battery Safety
• Do not throw into a fire
• Do not heat
• Do not charge
• Do not short circuit
• Do not disassemble
• Replace only with same or equivalent type
• Always observe local regulations when
disposing of a battery
• Detector will transmit low battery warning
when battery needs replacing
Reed Switch
Magnet
Non-Ferrous Mounting Material
•Maximum Break = 30mm
•Minimum Make = 15mm
Ferrous Mounting Material
•Maximum Break = 15mm
•Minimum Make = 5mm
Note: Values depend on
mounting material. See Fig.3
LED
Reed Disable
Disabled
Enabled
Range
High Range
Relearn
Low Range
Place jumper on Relearn pin
header and insert battery to
Sensitivity Adjust
learn device.
LED STATUS INDICATION
Only available in walktest mode
(See Premier wireless expander instructions)
Flashing Green:
Momentary
Green:
Momentary
Red:
Momentary
Orange:
26mm (1")
Reed
Disable
Range
MAX
88g (3.1oz) approx.
Comfort LED. When the reed switch is closed, the
comfort LED will flash green approximately every 3
seconds to indicate correct operation.
Background disturbance/under-sensitive setting.
This is used to indicate background disturbances or
an under-sensitive setting during installation.
Alarm condition/correct sensitivity. This is used to
indicate that an attack has been detected by the
shock sensor or a correct sensitivity setting during
installation.
Gross attack/over-sensitive condition. This is used
to indicate that a massive attack has been detected
by the shock sensor or an oversensitive setting
during installation.
130mm
(5.1")
13mm
33mm
-35°C (-31°F) to
+60°C (+140°F)
25mm (1")
-10°C (14°F) to
+55°C (+131°F)
STANDARDS
Alarm EN50131-2-2, EN50131-5-3, EN50131-1,
Systems: PD6662, Grade 2 Class II
EN50130-4:1995: A1: A2
EMC:
ETSI EN301 489-03 V1.4.1
R&TTE: ETSI EN300-220 (V2.1.1)
EN50130-5
Environmental:
868.0 - 868.6 MHz / 433.05 - 434.79 MHz
Frequency Band:
• Please refer to product label
GBB1000-2 Frequency 868MHz
Product Type:
GBB2000* Frequency 433MHz
Category 1, Class 2
Receiver:
Receiver LBT
Yes
(Listen Before Talk)
Transmitter Duty
868Mhz<1%, 433Mhz<10%
Cycle
Low Voltage
2.85V
Signal
Operating Voltage 3V
*GCC2000 is not INCERT approved
WARRANTY
2 year replacement warranty (excludes battery).
The Impaq Plus-W is designed to detect, the vibrations caused
by an intruder attempting to force an entry, or the opening of a door/
window and activate an alarm control panel. As the Impaq Plus-W is
not a complete alarm system, but only a part thereof, Texecom cannot
accept responsibility or liability for any damages whatsoever based on a
claim that the Impaq Plus-W failed to function correctly.
Due to our policy of continuous improvement Texecom reserves
the right to change specification without prior notice. All specifications
are measured at 20ºC (68ºF).
Made In
England
Cer tificate Number: FM 35285
Impaq and the wireless logo are trade marks of Texecom Ltd. © 2010
The Impaq Plus-W is protected by European Registered Design. No: 269188-0001
C20121008 INS512-5