Standard Oracode Gateway Diagnostics; Lock To Oracode Gateway “Connection” Status; Wireless Link Test; Oracode Gateway Reset To Factory Default - Dormakaba ORACODE 660i Manual

dormakaba
7

STANDARD ORACODE GATEWAY DIAGNOSTICS

1. LOCK TO ORACODE GATEWAY "CONNECTION" STATUS
• Entering # # # 2 on the lock keypad triggers a "Lock to Gateway" status test.
• A green LED and a high-pitched beep at the end of the test indicates the lock is connected to the Gateway.
• A red LED and a low-pitched beep at the end of the test indicates the lock is not connected to the Gateway.

2. WIRELESS LINK TEST

• This test requires the Gateway to be put in "Connect Mode" (by pressing the "Connect button" on the Gateway) if
the lock is not already connected to the Gateway (see 3.1).
• Entering # # # 1 on the lock keypad triggers a "Lock to Gateway" wireless link test.
• The lock's LEDs alternate green and red during the test which may be very quick or last over 30 seconds
(depending on if the lock is already connected to the Gateway network or not).
• A green LED and a high-pitched beep at the end of the test indicates a good link quality (success).
• A red LED and a low-pitched beep at the end of the test indicates a bad link (fail).
• If the Wireless Link Test fails, improve Gateway positioning (see 1.1) and re-execute the Wireless Link Test.

3. ORACODE GATEWAY RESET TO FACTORY DEFAULT

NOTE: You will need to get a new Activation Code from the Oracode Live web site to re-activate the lock (see Point
2) after you perform a Reset to Factory Default of the Gateway.
• Unplug the Power Supply from the Gateway for more than 5 seconds.
• Press and hold the "Connect Button" while you re-apply power to the Gateway.
• Hold the "Connect Button" until the green and red LEDs start blinking rapidly.
• Release the "Connect Button" and wait until the green and red LEDs turn off.
• Again, unplug the Power Supply from the Gateway for more than 5 secs and go back to Point 1.1.

4. ORACODE GATEWAY LED STATUS TABLE

GREEN LED
ON
OFF
FAST BLINK
FAST BLINK
OFF
SLOW BLINK
SLOW BLINK
SLOW BLINK SLOW BLINK
TECHNICAL SUPPORT HOTLINE
Call 1-888-217-5654 or 1-514-340-9025 (International)
Full service from 8:30 am to 7:00 pm Eastern Time
Emergencies 24/7
Email: techsupport.lgs.ca@dormakaba.com
www.dormakaba.com/us-en/support
5 PK3646_07_18
Oracode 660i Wireless Lock Activation/Programming
RED LED GATEWAY STATE
ON Power On (will be in this state for about 15 seconds).
OFF No Server connectivity. No ZigBee network.
FAST BLINK Red/Green alternates. Waiting for DHCP address assignment or server DNS
resolution.
FAST BLINK LEDs blink in unison. Reset to Factory in progress. This only lasts a few seconds
during reset.
ON* No eCode Server (Oracode Live) connection. * Could be fast, slow, or solid LED.
OFF Gateway ready. No ZigBee network.
ON Gateway ready. ZigBee network up. This is the normal Gateway operating state.
LEDs blink in unison. ZigBee network up. Connect Mode on.