Connecting The Rear Facing Camera; Powering The Car Dvr On / Off; Auto Power On/Off; Manual Power On/Off And Reset - NanoCam Plus NCP-DVRT1 User Manual

2.2.2 Connecting the Rear Facing Camera

The rear camera needs to be attached to your vehicles reverse light power cable for the reverse monitor function.
2.3

Powering the Car DVR On / Off

2.3.1 Auto Power On/Off

When the Car DVR is correctly installed and connected to your vehicle's 12v power supply, the Car DVR will automatically
power up and start recording when the vehicle accessories are activated.

2.3.2 Manual Power On/Off and Reset

2.3.2.1 Manual Power On

Hold the

2.3.2.2 Power Off

Make sure that recording has been stopped and then press the
powering down the device please wait for 10 seconds before turning the Car DVR back on.

2.3.2.3 Reset the Device

If the Car DVR does not function normally, try restarting the car DVR. To restart the car DVR, with a flattened paper
clip press the small button in the middle of the underside of the Car DVR.
2.4 Playing back video on a PC
To playback video files on your PC it is recommended to connect the Micro SD card (not included) directly to your PC using either
a USB Micro SD card reader (not included) or if your PC has a SD card slot, a Micro SD/SD Card converter (not included). Once
the Micro SD card is connected it should appear as a removable storage device. It is recommended that you transfer video files
that you want to playback to a file on your computer before attempting to playback. This will reduce any delay in playback.
Because each vehicle varies in the way that the reverse lights are wired, it is advised that
you review your vehicles owner's manual before attempting to connect the reverse camera.
(Power) button on the top of the camera until the NanoCam Plus start up screen appears.
When connecting the camera, be sure connect the RED cable to your
vehicles reverse lights positive wire, and connect the black cable to your
vehicles ground connection.
2.2.3 Connecting to Power
Only use the included charger to power and charge the Car DVR.
1. Once the Car DVR is securely installed on your vehicle's windscreen,
plug the 12v charger into your vehicle's cigarette lighter.
2. Run the cable along your vehicle's console and windscreen and plug
the power plug into the Car DVR.
(Power) button on the top of the car DVR. After
7