Install Crib Spring - Young America Baby 579-84-215 Assembly Instructions Manual

STEP 3.

Install crib spring.

1. The scissors brackets allow the crib spring to be installed at 3 different heights. The longer arm of the scissors bracket
is attached to hole "A" for shipping purposes (see SECTION "C"). The bolts and nuts for the shorter arm are attached to
the edge of the metal frame in holes "C" or "D". To achieve the lowest height, use the following combination of holes:
long arm attached to hole "A" – short arm attached to hole "D". The highest height is achieved by attaching the long arm
to hole "C" -short arm to hole "D" (This is the preferred height for a newborn). The middle position is attained by attaching
the long arm to hole "B" - short arm to hole "D". Make sure to attach the scissors brackets to the inside of the metal frame with
the head of the bolt going through from the outside of the frame. Attach all 4 scissors brackets using the same hole
combinations. Tighten the bolts with a flat head screwdriver, using a pair of pliers or adjustable wrench to hold the
nuts from the inside of the crib spring frame.
2. Position the crib spring so that the flat side of the frame is up and the scissors brackets point downward.
Carefully lower the crib spring into position so that the scissors brackets are on the outside of the stabilizer bars.
Align the holes in the end of the long arm of the scissors bracket with the holes in the stabilizer rails. Put washers on
the bolts from the inside of the stabilizer rails and attach using the nylon locking nuts that are provided, using a
flat head screwdriver and a pair of pliers or adjustable wrench to hold the nylon locking nuts from inside the stabilizer rail.
3. Tighten bolts securely.
youngAmericababy
A trademark of Stanley Furniture Company, Inc.
™
7