Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JOSEF DAVIDSSONS JD 320
Summary of Contents for JOSEF DAVIDSSONS JD 320
- Page 1 JD 320/Viking 30 Installation and maintenance manual...
-
Page 2: Table Of Contents
Technical data What comes with the stove JD 320/Viking 30 wood stove dimensions and installation 6 – 7 About the JD 320/Viking 30 8 Operation of your JD 320/Viking 30 Installation and connection Connecting outdoor air to the wood stove Replaceable parts... - Page 3 Congratulations on your new JD 320/Viking 30! All of us at Josef Davidssons Eftr. hope that, like many others around the country, you will have many happy hours in the kitchen. The JD 320/Viking 30 is a fine wood stove which works equally well for cooking and for cold winter evenings.
-
Page 4: Technical Data
GET STARTED: Efficiency (%) Fitting by a professional Output (kW) 3–8 The manual contains instructions on how the JD 320/ Heating capacity (approx. m²) up to 80 Weight (kg) Viking 30 should be fitted and installed. To guarantee the function and safety of the stove, we recommend instal- Size (H x W x D mm) 850–900 x 300 x 600... -
Page 5: What Comes With The Stove
For fitting instructions, see page 10. Practical poker included. A. With Viking 30. B. With JD 320. TIP: The pallet is classed as untreated wood. Corrugated cardboard goes into card and plastic tape into the combustible bin at the recycling centre. -
Page 6: Jd 320/Viking 30 Wood Stove Dimensions And Installation
JD 320/VIKING 30 WOOD STOVE DIMENSIONS AND INSTALLATION The pictures show the major dimensions required for correct installation and optimum function. All dimensions are given in millimetres. VIKING 30/JD 320 Ext. Ø 60 (outdoor air connec on) Ext. Ø 60 (outdoor air connec on) - Page 7 Installation clearances Flammable wall Observe the safety clearances for installation. 125 mm 300 mm Lowest possible ceiling height for proper safety clearance is 2000 mm. In front of the wood stove there must be a clearance of at least 1,000 mm to flammable material. 150 mm The clearances relate to installation with an insulated outlet pipe.
-
Page 8: About The Jd 320/Viking 30
General The total height of the stove is adjustable between 850 The JD 320/Viking 30 is made of heavy cast iron and the and 900 mm (900–920 mm with an extension set). Lift firebox is lined with vermiculite. Between the vermiculite... -
Page 9: Operation Of Your
OPERATION OF YOUR JDE 320/VIKING 30 Combustion air Convection air The primary air is supplied when the fire door is left ajar as Apart from radiating heat, the JDE 320/Viking 30 is also wood is fed in and during the lighting-up phase. The sec- designed for convection. -
Page 10: Installation And Connection
INSTALLATION AND CONNECTION is. The minimum recommended chimney length is 3.5 m and a suitable cross-sectional area is 120–180 cm² (125 mm in diameter). The wood stove meets the requirements for connec- A flue with sharp bends and horizontal sections will re- tion to chimneys designed for a smoke temperature of duce the draught in the chimney. -
Page 11: Connecting Outdoor Air To The Wood Stove
CONNECTING OUTDOOR AIR TO THE outdoor air to your wood stove depending on the type of house that you have. Some take air directly via the WOOD STOVE outside walls, others go down into the floor and then out through the foundations. If you go down into the For optimum performance, the firebox needs around floor, it is important for the supply pipe to be insulated 20 m³... -
Page 12: Replaceable Parts
REPLACEABLE PARTS The JD 320/Viking 30 has been built for use several decades into the future, but do not forget to replace wear parts when necessary. Keep an eye on vermiculite firebricks, grate and seals, and replace the parts when they get worn. -
Page 13: How To Replace Vermiculite And Back Plate
HOW TO REPLACE VERMICULITE AND BACK PLATE NOTE: Never unscrew the top of the stove. This will invalidate the warranty. 1. Remove the hotplate 2. Open the fire door and insert a thin tool (such as a screwdriver) into one of the holes in the centre firebrick. NB: Always start with the centre brick. -
Page 14: Maintenance, Cleaning The Stove
Take good care of your stove and apply stove black when First firing necessary. A new JD 320/Viking 30 should be fired carefully the first few times. Then the heat-resistant paint will last The grate should be regularly shaken and cleared of ash. -
Page 15: Problem-Solving
FIRING PROBLEMS AND SOLUTIONS Poor draught • The connection to the chimney stack has not been sealed properly. Ask the sweep to check that the joint between the stove and the chimney is completely tight. • The flue is sooted up. Clean the flue and firebox. •... -
Page 16: Warranty
The warranty applies from the date of delivery to the customer. Josef Davidssons Eftr AB accepts no liability for removal and installation costs for replacing a stove. Josef Davidssons Eftr AB accepts no liability for costs arising from downtime or other direct or indirect costs and damages. - Page 20 Our customer service desk will give you personal assistance and answer your questions. Contact us by post, telephone, fax or e-mail. Josef Davidssons Eftr AB, Jättevägen 1, 333 75 Reftele, Sweden Tel: +46(0)371 – 200 01 Fax: +46(0)371 – 210 01 info@josefdavidssons.se...
Need help?
Do you have a question about the JD 320 and is the answer not in the manual?
Questions and answers