Strongarm SA5000AC Owner's Manual

Strongarm SA5000AC Owner's Manual

120 volt ac electric winches

Advertisement

OWNER'S
MANUAL
MODELS SA5000AC, SA7000AC,
SA9000AC, SA12000AC
WARNING:
ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE STRONGARM
ELECTRIC WINCH. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT
IN SERIOUS OR FATAL INJURY. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
ELECTRIC WINCH RATING*
5000
4500
4000
3500
3000
2500
2000
1500
1000
500
10
LENGTH OF CABLE ON REEL (FT.)
GUIDE TO ROLLING LOAD CAPACITY**
Maximum weight in pounds and kilograms rolling load.
MODEL
5%
10%
(3°)
(6°)
8,000 lbs. 6,000 lbs. 4,000 lbs. 3,100 lbs. 2,200 lbs. 1,800 lbs.
SA5000AC
3,629 kg 2,722 kg 1,814 kg
12,000 lbs. 9,000 lbs. 6,100 lbs. 4,600 lbs. 3,300 lbs. 2,700 lbs.
SA7000AC
5,443 kg 4,082 kg 2,767 kg
18,000 lbs.13,500 lbs. 9,100 lbs. 6,900 lbs. 5,000 lbs. 4,100 lbs.
SA9000AC
8,165 kg 6,124 kg 4,128 kg
26,700 lbs. 20,100 lbs.13,600 lbs. 10,300 lbs. 7,400 lbs. 6,100 lbs.
SA12000AC
12,111 kg 9,117 kg 6,169 kg
(*) Load capacity (dead weight) is a measure of actual maximum force to which the
winch system may be subjected.
(**) All capacities shown are with 15' of cable on the reel and 10% rolling friction factor.
For full reel of cable adjust capacities according to graph above. Note 5% incline is
one-half foot rise in ten feet.
READ INSTRUCTIONS CAREFULLY BEFORE
WINCH RATINGS
20
30
40
PERCENT INCLINE
20%
30%
50%
(11°)
(17°)
(26°)
1,406 kg
998 kg
2,087 kg 1,497 kg 1,225 kg
3,130 kg 2,268 kg 1,860 kg
4,672 kg 3,357 kg 2,767 kg
®
DOUBLE LINE OPERATION
Models SA7000AC and SA12000AC are factory
equipped with a pulley block and hook and 50' of
cable for double line operation. This increases the
pulling capacity of the winch as shown, however,
care must be taken to allow adequate motor cool-
ing. Note that with double line, a pull of 25' requires
reeling in 50' of cable.
For intermittent use only. Ratings at left are based
on 10' pull. For longer pulls motor cooling periods
must be allowed.
MAXIMUM CONTINUOUS RUN TIME 3 MINUTES
CAUTION: CONTINUOUS RUNNING IN
50
EXCESS OF 3 MINUTES WILL DAMAGE WINCH
MOTOR.
LOAD
70%
CAPACITY*
(35°)
1,200 lbs.
816 kg
544 kg
1,800 lbs.
816 kg
2,700 lbs.
1,225 kg
4,000 lbs.
1,814 kg
1
120 Volt C
ELECTRIC WINCHES
APPROXIMATE LOAD SPEED
(FT./MIN.)
NO LOAD
Full
Empty
Reel
Reel
35
16
SA5000AC
17.5
8
SA7000AC
SA9000AC
18
6
9
3
SA12000AC
WARNING: NOT TO BE
USED AS A HOIST FOR
LIFTING, SUPPORTING OR
TRANSPORTING PEOPLE OR
LOADS OVER AREAS WHERE
PEOPLE COULD BE PRESENT!
E
N
G
L
I
S
H
E
S
P
Ñ
O
L
F
R
FULL LOAD
Full Empty
N
Reel Reel
Ç
16
9
I
9.5
6
S
7
3.5
4
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SA5000AC and is the answer not in the manual?

Questions and answers

Summary of Contents for Strongarm SA5000AC

  • Page 1 MODELS SA5000AC, SA7000AC, SA9000AC, SA12000AC WARNING: READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE STRONGARM ELECTRIC WINCH. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN SERIOUS OR FATAL INJURY. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE. WINCH RATINGS ELECTRIC WINCH RATING*...
  • Page 2: Important Safety Information

    IMPORTANT SAFETY INFORMATION WARNING: FAILURE TO READ AND FOLLOW INSTRUCTIONS BELOW COULD RESULT IN SERIOUS OR FATAL INJURY. WARNING: NOT TO BE USED AS A HOIST FOR LIFTING, SUPPORTING, OR TRANSPORTING PEOPLE OR LOADS OVER AREAS WHERE PEOPLE COULD BE PRESENT. This winch is not designed for movement of When winching operation has been completed, human beings.
  • Page 3: Mounting Instructions

    BASE HOLE PATTERN FIG. 2 WARNING: ALWAYS MAINTAIN CONTROL OF (SA5000AC & SA7000AC) THE LOAD. ALLOWING EXCESS SPEED COULD RESULT IN WINCH DAMAGE AND SEVERE PER- SONAL INJURY. 3. Remember that the gear train and brake mechanism are completely disengaged in the “Free Wheel”...
  • Page 4: Auxiliary Handle

    NOTE: CABLE IS WOUND OVER THE engaged position. To make cranking easier, the TOP OF THE DRUM ON MODELS SA5000AC AND clutch can be placed in the free wheel position while SA7000AC AND UNDER THE DRUM ON MODELS holding onto the emergency handle.
  • Page 5 5. Check the pulley block and hook assembly (MODELS SA7000AC AND SA12000AC) to be sure that the pulley rotates freely on the bronze pulley spacer. Occasional greasing of these two items is recommended. FIG. 6 O-Ring Illustration spring keeper and reinstall the clutch spring into Clutch Spring the hole in the base.
  • Page 6 WIRING DIAGRAM SA5015AC/7015AC WIRING DIAGRAM SA5000AC/7000AC SA5000AC and SA7000AC PARTS LIST Ref. Part Number Ref. Part Number Ref. Part Number MOTOR PARTS Retaining Ring (2) 205191 AA Screw-1/4-20x5/8 (3) 205238 Bushing 204012 AB Locknut, 10-32 (2) 205193 CA Motor Ass’y.
  • Page 7 WIRING DIAGRAM SA9000AC/12000AC WIRING DIAGRAM SA9015AC/12015AC SA9000AC and SA12000AC PARTS LIST Ref. Part Number Ref. Part Number MOTOR PARTS Bearing Housing Assy. 304314 AC Level Wind Pin 404516 DA Motor Assy 304921 Primary Drive Shaft Assy. 304304 AD Level Wind 204709 DC Strain Relief Bushing 206670...
  • Page 8 Tel: 407-843-4220 Tel: 816-632-6578 Tel: 402-462-4141 Tel: 631-543-6433 These authorized centers will be able to supply parts and technical service on all StrongArm Electric Winches ® For warranty claims follow instruction given in “Limited One Year Warranty.” DECLARATION OF CONFORMITY - Dutton-Lainson Company, Hastings, NE 68902-0729 U.S.A. manufactures and declares that the winch identified above fulfills all relevant provisions of the Directive 2006/42/EC.

This manual is also suitable for:

Sa12000acSa9000acSa7000ac

Table of Contents