Replacing Ink Filter Inside The Gun - EBS -6100 User Manual

EBS-6100 Printer User's Manual
Paragraph 6 - SERVICE and maintenance
!
These components
must not be
replaced with
others as such
a replacement may
cause the lack of
tightness!!!
Contaminations may get into the printer's ink system during replacement of the main ink filter.
Therefore it is recommended that the filter replacement be followed by a slightly shorter,
about 10-minute ink filtering procedure similar to that described before.

Replacing Ink Filter Inside the Gun

Replace (clean out) the ink filter inside the head gun by following the steps below:
• wait until impurities deposit on the filter and select the V0 OFF command (or press
• wash the nozzle with solvent,
• use a size 4 open ended spanner to unscrew sleeve
• pull out the unscrewed pipe and the fixing sleeve
• using an open ended spanner size 8 unscrew the filter fitting for gun
• remove the ink filter
• assemble the above-mentioned parts in the reverse order,
• select the V0 ON command (or press the INK ON/OFF key on the external panel) in
NOTE: Each time the gun filter is replaced the nozzle clogs up. Remember to clean the
nozzle afterwards – see subsection
112
R3
Ink level
Fig. 6.3.5.1. Replacing the main ink filter
the INK ON/OFF key on the external panel) in order to stop the flow of ink to the
head; the V0 lamp on the internal panel goes out,
the tube that supplies ink to the gun. Use size 8 open ended spanner to hold up the
filter fitting, if need be,
filter fitting from the gun and wash with solvent,
, insert a new one in the proper direction or wash the existing
filter thoroughly if possible,
order to let the ink flow to the head (the lamp V0 on the internal panel comes on).
Main ink filter
OUT
This sleeve must be replaced
IN with a new one each time the
ink filter is changed !!!
6.3.3 Clogged nozzle - cleaning the
EBS
Ink-Jet Systems
, which is used to hold down
,
, remove the
nozzle.
20070529#20.5
®