Interphone OFFROAD Quick Manual

EN
QUICK GUIDE
WE RECOMMEND YOU CHECK FOR
SOFTWARE UPDATES ON THE WEBSITE
WWW.INTERPHONE.COM
www.interphone.com
5
1 - MFB (multifunction button)
2
2 - UP button ▲
3 - + volume button
4 - – volume button
5 - Multifunction LED
3 7
6 - Multifunction LED
7 - Multifunction audio/data port
8 - Mounting guides for Bluetooth® module
9 - Charging connector
1
6
4
7
8
A
B C
ASSEMBLY OF THE SLIDE SUPPORT
WITH REMOVABLE CLIP
Take the support and note the best place
to fasten it to the side of the helmet. Insert
the rear part of the clip into the helmet and
attach the other part on the outside.
Insert the screws and
tighten gently.
PHASE 1 PHASE 2
Check position and move
the support if necessa-
ry, by sliding it along.
Tighten the screws with
the screwdriver supplied.
(images A/B)
PHASE 3 PHASE 4
ASSEMBLY OF THE ADHESIVE SLIDE
SUPPORT
Take the adhesive support and look for the
best side and place to position it. Clean and
de-grease the part of the helmet where you
are going to stick the support (do not use
any detergents that could damage the hel-
met's finish). Remove the
protective film from the
double sided tape, and
apply the support to the
helmet.
PHASE 1 PHASE 2
As the support cannot
moved once it is attached
to the helmet, take great
care with its positioning
when applying.
(image C)
PHASE 3 PHASE 4
MOUNTING ON
FULL-FACE HELMET
A - GREEN
B - RED
9
MOUNTING ON MOUNTING ON
FULL-FACE HELMET OPEN-FACE HELMET
MOUNTING ON
OPEN-FACE
HELMETs