Table of Contents
Advertisement
II. Hardware Installation
6. Ground yourself to an antistatic mat or other grounded source.
7. Pick up the board (still in its sleeve) by grasping the edge bracket with one
hand. Avoiding touching board components.
8. Remove the plastic sleeve.
9. Position the card directly over the PCI slot and insert one end of the board in
the slot first. Carefully press the bus connector on the bottom of the card down
into the slot. Be sure the metal contacts on the bottom of the host adapter are
securely seated in the slot.
10. Anchor the board's mounting bracket to the computer chassis using the screw
from the slot cover you set aside previously.
11. Replace the cover on the system unit.
12. Connect your analog monitor's 15-pin VGA connector to the card and fasten
the retaining screws (if any).
13. Connect other cables and devices if available.
10
ASUS 3DP-V375 DX User's Manual
Advertisement
Table of Contents
