Sonet:aps:rx Pt :K1 - Anritsu MT1000A Network Master Pro Remote Scripting Operation Manual

Chapter 11 SONET
11.6.14

SONet:APS:RX Pt :K1

Syntax SONet:APS:RX Pt :K1
Description This command sets the destination node/source channel (K1).
Parameters Pt
value
MINimum=0, MAXimum=15, DEFault = 0
Response None.
Example
SON:APS:RX1:K1 3
Notes Cannot be changed if the SONet:APS:CONFig command is set to LIN, 1P1.
Changes to SONet:APS:CONFig will reset this value to 0.
Syntax SONet:APS:RX Pt :K1?
Description This query returns the destination node/source channel (K1).
Parameter Pt
Response value
Example
SON:APS:RX1:K1?
Note
11.6.15 SONet:APS:RX Pt :K2
Syntax SONet:APS:RX Pt :K2
Description This command sets the source node/bridged channel (K2).
Parameters Pt
value
MINimum=0, MAXimum=15, DEFault = 0
Response None.
Example
SON:APS:RX1:K2 3
Notes Cannot be changed if the SONet:APS:CONFig command is set to LIN, 1P1.
Changes to SONet:APS:CONFig will reset this value to 0.
Syntax SONet:APS:RX Pt :K2?
Description This query returns the source node/bridged channel (K2).
Parameter Pt
Response value
Example
SON:APS:RX1:K2?
Note
11.6.16 SONet:APS:RX Pt :APPLy
Syntax SONet:APS:RX Pt :APPLy
Description This command applies the K1/K2 request setup to the transmitter.
Parameter Pt
Response None.
Example
SON:APS:RX1:APPL
Notes
11.7 Tributary Scan
11.7.1 SONet:TSCan:STARt
Syntax SONet:TSCan:STARt
Description This command starts the tributary scan test.
Parameter None.
Response None.
Example
SON:TSC:STAR
Note It is possible to run only one test or measurement at a time. The SONET interface must be
active for at least one of the receivers.
372
value
= Port number
= NUMERIC PROGRAM DATA
= Port number
= NR1 NUMERIC RESPONSE DATA
3
value
= Port number
= NUMERIC PROGRAM DATA
= Port number
= NR1 NUMERIC RESPONSE DATA
3
= Port number