Sharp HT-SB32D Quick Start Manual page 2

System preparation
Make sure to unplug the AC power lead before installing the sound bar or changing the position.
1 Peel the double sided tape separator.
Spike leg
To mount the sound bar on the wall
1 Fix the pattern paper to the wall in horizontal
position as below.
Wall
surface
44 mm
2 Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
8-9 mm
3 Fix a wall mount plug into the hole using a ham-
mer, until it is flush with the wall surface.
8-9 mm
Double sided
tape separator
509 mm
548 mm
Pattern paper
(supplied)
32 mm
Wall surface
32 mm
Wall surface
2 Fix the spike leg onto the sound bar as shown.
Bottom of
sound bar
4 Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Screw using
Screwdriver
Wall surface
4.5 mm - 5 mm
Gap from wall surface
Wall surface
5 Hang the sound bar onto the screws.