boori Pioneer Cot/Bed Instructions page 3

Assembly as a Cot:
Connect fixed side panel to the two end panels with the 4 X70mm
connecting bolts provided.(Do not tighten at this stage).
42
Stage 1
:
Connect mattress base to the two end panels with the 4 X80mm
connecting bolts provided.(Keep all bolts loose at this stage).
Stage 2:
The upper holes on the end panels are for the high base position.
Screw 4 dropside glide pins into the end panels (Make sure they are tight).
Note :
Push both end panels outward to allow space for assembly of dropside
panel.Allow glide pins of one end panel into the runner first.Then allow
the pins on the other into the runner by pulling both end panels inward.
Stage 3
:
Ensure that correct side is facing out (see photograph)
Fully screw in the bolts on both end bars of dropside panel.
Tighten all the connecting bolts.(Do not over tighten).Block remaining
holes on the end panel with 4 capping bolts ane 4 capping nuts provided.
To disassemble the cot just follow assembly instructions in reverse
order.
To lower the dropside panel pull the dropside panel up to the top
position.Hold it in that position while using your leg to push (at the centre
of bottom bar) inward.Then allow the dropside panel to slide down.
To raise the dropside panel ,pull the dropside panel up (from centre of
the top bar) until it clicks into the locking position.
Note
:
Remove the drop side (see cot assembly instructions).
Remove the 4 drop side glide pins.
Reposition the base to the lower position (bottom hole of end panels).
Remove the fixed side.
Block the top whole with the 40mm connecting bolts and capping nuts
provided.
Converting to the Junior Bed
: