Miele CS 1112 User Manual page 8

Technical safety
~
The appliance may only be
operated when the following conditions
are met:
– the list of the vessel is not more than
2°.
– any external vibration is no more than
150 Hz at an amplitude of 0.35 mm.
The safe operation and correct
functioning of the appliance can only
be guaranteed if the above
conditions are met.
~
The appliance may not be operated
on an open deck.
~
Appliances not marked with the
CSA C/US Safety Label comply with
European safety regulations. These
appliances may not be operated in the
USA.
~
A risk assessment of the installation
must be carried out by a suitably
qualified engineer before this appliance
is installed or used. Installation must
only be carried out by a suitably
qualified engineer.
~
The appliance must be fixed in
position when it is installed. Failure to
do this could result in damage to the
appliance, personal injury and damage
to property.
~
Before installation, check the
appliance for visible signs of damage.
Do not use a damaged appliance. It
could be dangerous.
Warning and Safety instructions
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
~
The electrical safety of this
appliance can only be guaranteed
when continuity is complete between it
and an effective earthing system which
complies with local and national safety
regulations. It is most important that this
basic safety requirement is present and
regularly tested, and where there is any
doubt, the on-site wiring system should
be inspected by a qualified electrician.
Miele cannot be held liable for the
consequences of an inadequate
earthing system (e.g. electric shock).
~
Before connecting the appliance,
make sure that the connection data on
the data plate (voltage and frequency)
match the mains electricity supply.
This data must correspond in order to
avoid the risk of damage to the
appliance. Consult a qualified
electrician if in any doubt.
~
For safety reasons, this appliance
may only be used after it has been built
in.
~
Do not open the casing of the
appliance.
Tampering with electrical connections
or components and mechanical parts is
highly dangerous to the user and can
cause operational faults.
~
Installation, maintenance and
repairs may only be carried out by a
suitably qualified and competent
person in strict accordance with current
national and local safety regulations.
Repairs and other work by unqualified
persons could be dangerous. Miele
cannot be held liable for unauthorised
work.
7