CONTROL SOLUTIONS Babel Buster 2 Quick Start Manual

Babel Buster BB2-7010-07 Quick Start Guide

Initial Startup

1. Connect power. Apply +12 to +24VDC or 24VAC to the terminal
marked "POWER", and common or ground the the terminal marked
"GND". Connect a CAT5 cable between the RJ-45 jack on the top and
your network switch or hub. You cannot connect directly to your PC un-
less you use a "crossover" cable.
2. The default IP address as shipped is 10.0.0.101. If using Windows XP,
you may need to add a route on your PC. However, Windows 7 and be-
yond should be able to browse directly to the device.
3. Open your browser, and enter "http://10.0.0.101/" in the address win-
dow. You should see a page with the "Babel Buster BB2-7010" header
shown above. From this point, you will fi nd help on each page in the web
site contained within the product. You can change the IP address on the
System -> Setup -> Network page.
4. The default login is user name "system" with password "admin". You
can also log in as "root" using password "buster".
5. Be sure to save any confi guration changes you made on the System
-> Setup -> Confi g File page. Your changes will be lost upon next pow-
er cycle if you do not click Save on the Confi g File page.
ZL0155-0A
Th e BB2-7010-07 is designed to interface
Veris Industries WiFi sensors with a BAC-
net IP network (or Modbus or SNMP).
WiFi access is via any standard WiFi ac-
cess point or router confi gured to simply
be just an access point. Using standard off
the shelf WiFi access points allows WiFi
reception to be distributed for best perfor-
mance while still using a single gateway to
translate sensor data for BACnet IP use.
Getting data from sensors that have been confi gured to send to the IP ad-
dress of the BB2-7010-07 is as simple as just entering the sensor's MAC
address on the Sensor -> Sensor Setup page. Th en go to the Sensor Data
page and watch for data to show up.
Data will appear on the Sensor Data page as a diagnostic regardless of
whether any BACnet data objects have been assigned. To cause the data
to be available via BACnet, assign data objects as illustrated below. Addi-
tional information may be found in the "Quick Help" section found at the
bottom of each page.
Go to csimn.com/ticket if you need technical assistance.