Initial Device Setup; Factory Reset - Attero Tech unBT2A User Manual

4 – Initial Device Setup
*Note: Once the wall plate is installed in the wall, the USB port used for configuration will not be accessible. It is
therefore recommended setup be completed before installing the wall plate into the wall.
The unBT2A features software configuration and status monitoring of the following device parameters using in Attero
Tech's unIFY Control Panel software (V2.1 or later):
Bluetooth® friendly name (Default: unBT2A)
o
unBT2A status
o
Pairing button control
o
Mono/Stereo output selection
o
Analog output sensitivity
o
Remote pairing activation/deactivation
o
Clear pairing list
o
The unIFY Control Panel software will install any necessary drivers required by the operating system for compatibility with
the unBT2A.
To configure an unBT2A, connect the mini-USB cable between the PC running unIFY Control Panel and the unBT2A. The
unBT2A can be bus powered via the USB for initial setup.
*Note: The audio outputs of the unBT2A will not operate while only connected to USB. However, the device will allow the
integrator to pair to the device and test any customizations applied to the device. If it is necessary to test the audio output
while connected to the USB, connect the full unBT2A-EXP in order to fully power the device.
Once the unIFY Control Panel application is open, select the unBT2A "Configuration" menu item from the "Tools" menu.
From here, the audio output mode can be configured based on the application needs. The mono output mode is useful
for systems that utilize mono playback systems and wish to maximize the input channel capacity of the system. The
mono output signal is the sum of both channels at 50% volume sent to each output. Stereo output mode sends the
left/right channels separately to each output at 100% volume. For a complete description of the software features, refer
to the unIFY Control Panel user manual.
4.1 – Factory Reset
 Attero Tech LLC 2018
The unBT2A has a factory reset option. Using it will reset all the devices parameters back to
their factory defaults. The devices IP address mode is also reset back to getting a dynamic IP.
Access to the factory reset button is through a small circular hole on the side of the unit.
To use the factory reset, be sure the unit is powered up and insert a small screwdriver or
paperclip into the hole to activate the factory reset switch. There should be a noticeable "click"
when it's activated. Hold the switch in for 5 to 10 seconds and release the switch. If the factory
reset was successful, the left hand LED will briefly glow red and then change to green. If not,
the reset switch was not held in long enough.
Page 9
unBT2A
User Manual
614-00034 Rev 01_d