Zomm Wireless Leash Quick Start Up Manual

in the box
World's First Wireless Leash ™ for Mobile Phones
Thank you for choosing ZOMM.
If you have any questions, please contact our support team at support.zomm.com.
®
one ZOMM
one quick-release one visor clip
Wireless Leash keychain

quick start guide

one car charger one micro-USB one USB
charging cable wall charger
visit zomm.com to customize and receive © ZOMM, LLC 2010, 2011 ALL RIGHTS RESERVED
MATERIAL PRESENTED WITHIN SUBJECT TO CHANGE WITHOUT NOTICE
updates for your ZOMM BLUETOOTH® IS A TRADEMARK OWNED BY THE BLUETOOTH SIG, INC. AND IS USED UNDER LICENSE
ZOMM® IS A TRADEMARK OF ZOMM, LLC WIRELESS LEASH™ IS A TRADEMARK OF ZOMM, LLC
myZOMM™ IS A TRADEMARK OF ZOMM, LLC
customizing the ZOMM
about the ZOMM Wireless Leash
Be sure to customize your ZOMM with myZOMM to get
all the latest features and updates!
1. Navigate to zomm.com.
Z-button (with Z-light)
2. Click on the myZOMM link at the top of the page.
3. Log in or create an account.
perimeter alert light
4. Follow the instructions to update or customize your ZOMM.
noise-cancelling microphone
metal loop
reset button
high-powered micro-speaker
micro-USB port with dust cover
using the visor clip
using the quick-release keychain
1. Attach the ZOMM to one of the four quick-release key rings. 1. Slide the clip onto the right-hand side of your visor with the
2. Pull the quick-release slide toward the center of the key-ring ZOMM holder facing down.
hub to remove or re-attach any of the key rings. 2. Snap the ZOMM into the visor clip with the Z-button facing
3. The quick-release slide will spring back into the locked down and the metal loop toward the windshield.
position when you let go of it. 3. To remove the ZOMM from the clip, pull the metal loop
downwards.
Keychain (closed)
Keychain (open)
insert keyring in Insert into visor clip Pull the metal loop
open slot
as shown downwards to remove
charging the ZOMM
USB Wall Charger:
1. Gently open the dust cover. 3. Insert the USB cable into the wall charger and
then plug the wall charger into a wall outlet.
2. Insert the micro-USB end of the charging cable into the
ZOMM's micro-USB port.
Computer:
3. Insert the cable into one of your computer's USB
ports. Make sure your computer is on and awake
for the duration of the charge.
Car Charger:
3. Insert the USB cable into the car charger and then
insert the car charger into your car's power port
Low Battery Alert: When the battery level is low, the ZOMM will alert you by or cigarette lighter.
sounding three short beeps every few minutes.
NOTE: If the ZOMM is on and connected to your phone, all of its features
will function while charging.
When charging, the Z
remain lit. For best battery life, fully charge the ZOMM for 4 hours.
pairing the ZOMM
1. Ensure your phone is turned ON and the Bluetooth
feature is enabled.
2. Verify that the ZOMM is unplugged and turned OFF
(Z-light is OFF).
3. Press and hold the Z-button until you hear the second beep
(9 seconds).
4. On your phone, search for Bluetooth devices.
5. Select the ZOMM from the list of found Bluetooth devices
on your phone.
6. Pair and connect the ZOMM. If a PIN is required, use 0000.
connect
to
ZOMM?
0000
off off hold until
2nd beep
every few seconds.