3- Install The Cpu Card - NEC SL2100 Quick Install Manual

Install the ISDN PRI Card

3- Install the CPU Card

The SL2100 chassis does not have any CPU card pre-installed, you install the card of your choice.
There are two CPU card available:
IP7EU-CPU-C1
IP7EU-CPU-C1-A
Ensure the SL2100 system is powered off before removing or inserting the CPU card.
Fit the memory backup battery (CR2032 type)
The + symbol must be on top, as shown below.
Fit the optional items to the CPU card, if applicable:
IP7WW-SDVMS-C1 /
P7WW-SDVML-C1
IP7WW-EXIFB-C1
P7WW-VOIPDB-C1
Refer to the Quick Install Guide for the type of terminals you will be connecting:

SL2100 Quick Install Guide – InMail Voicemail

SL2100 Quick install Guide – VoIP
Note – Both CPU cards may not be available in your region.
Quick Install Guide – SL2100 with ISDN PRI Trunks rev 1.1
SL2100 Main Processor Board
• VoIPDB Daughter Board Connector : 1
• EXIFB Daughter Board Connector : 1
• SD Card Slot : 1
• Built-in 4ch of VRS (Not supported for VM without SDVML/SDVMS)
• Built-in 8ch VOIP resources
The hardware is same as IP7EU-CPU-C1.
The feature Includes:
• Built-in 4ch of VRS/InMail voicemail
• 4pc of SL2100 IP TRUNK-01 LIC
• 4pc of SL2100 IP EXT-01 LIC
SD Card for VRS/VM (InMail) Storage 15/20 hour
System Expansion Bus Daughter Board (mount to CPU)
• 2 Bus connectors for Expansion Chassis
• Additional Telephony Resources
• VRS/VM (InMail) Channels expansion (up to 16ch)
• Analog Modem (V.34)
VoIP GW Daughter Board (mount to CPU) 16ch VOIP resources, maximum
128ch with licenses
13