Advertisement

Owner's Manual — Phoenix Guardian R
The Phoenix Guardian R HEPA System is the most compact,
portable unit in our popular line of high performance
airscrubbers. The Phoenix Guardian R features a 22" x 24"
footprint and stands only 14" tall. Weighing less than 35 lbs
and featuring a molded handle and stackable design, the
Guardian R is easy to carry, transport, and store.
 For maximum flexibility, the Phoenix Guardian R features 
variable airflow and can be operated vertically or 
horizontally. The Guardian R is designed to accept 16" inlet
flex duct and 10" lay flat outlet duct for a variety of operating 
set-up options.
 The Guardian R delivers a maximum 500 CFM of HEPA 
filtered air, while drawing less than 2.5 amps of power.  This 
makes the Guardian R HEPA System perfect for a variety
of remediation projects where space and power are at a 
premium. A single Guardian R is capable of providing 4 air
changes per hour (the recommended minimum) on a 7500 
cubic foot room (more than a 30' x 30'x 8').
 The Guardian R HEPA System's 2-stage filter design - with 
documented true HEPA filtration performance - will remove 
hazardous particles from the air and, with the addition of an 
optional carbon/potassium permanganate filter, will adsorb a 
wide range of odors and gases.
The Phoenix Guardian R HEPA System
•  Compact design 
•  Variable speed flow
•  Multiple ducting options
• Tough, plastic cabinet
•  Optional carbon filter
Specifications subject to change without notice.
Toll-Free 1-800-533-7533
4201 Lien Rd • Madison, WI 53704
Installation, Operation & Service Instructions
Read and Save These Instructions
Phoenix now offers
this unit in both
Red and Blue
www.UsePhoenix.com • sales@UsePhoenix.com
Phoenix Guardian R
PN 4031350 (Red)
4031460 (Blue)
TS-705
01/17 Rev. A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4031350 and is the answer not in the manual?

Questions and answers

Summary of Contents for Phoenix 4031350

  • Page 1: Introduction

    Owner’s Manual — Phoenix Guardian R Installation, Operation & Service Instructions Read and Save These Instructions The Phoenix Guardian R HEPA System is the most compact, portable unit in our popular line of high performance airscrubbers. The Phoenix Guardian R features a 22” x 24”...
  • Page 2: Table Of Contents

    The Guardian R should be transported vertically or Guardian R HEPA System. horizontally on the appropriate feet located on the bottom of the unit or opposite the handle 3.2 Electrical Requirements The Phoenix Guardian R HEPA System can be plugged into a grounded 15 Amp circuit. It draws about 2.4 Amps with clean  filters and no ducting. The amp draw will decrease slightly  with added ducting and as the filters load with particulate. Due to the presence of GFCI receptacle, the unit must be ...
  • Page 3: Air Ducting

    3.3 Air Ducting 3.3C Negative Air Ducting The Phoenix Guardian R HEPA System can be used to filter  3.3A Inlet Ducting and exhaust air from a space. When exhausting to outside Occasionally the area to be filtered is difficult to access and/ the space, the space will be under a slight negative pressure.  or the unit cannot be located in the area. In such cases, the  This will help prevent airborne particles from leaving the  air can be ducted to the unit’s inlet. space, because the negative pressure will draw air in through  A round 16” diameter flexible duct can be attached to the  openings in the space’s exterior surfaces. unit inlet. It connects by placing the wire in the duct over the  duct collar lip at one location and working over it over the lip  gradually. It may be removed after use for easier transport  and storage. Flexible 16” duct is available from Therma-Stor CAUTION: Exhausting too much air from a space with open LLC. (4028357)
  • Page 4: Resettable Circuit Breaker

    Guardian R on-board circuit breaker prevents are contained and disposed of properly. nuisance visits to a remote power junction box. 4.1 Air Filters The standard Phoenix Guardian R HEPA System is equipped with two filters that progressively filter out smaller particles.  IMPORTANT: Total amperage of the Guardian R plus all An optional activated carbon/potassium permanganate filter  devices plugged into the receptacle must not exceed 12 can be also added. These filters must be checked regularly. ...
  • Page 5: B Optional Activated Carbon/Potassium

    If the airflow is still too low, the HEPA filter must be changed.  To remove the HEPA filter, follow these steps: 1.  Loosen the eight screws  one revolution CAUTION: Servicing the Phoenix Guardian R HEPA System 2. Rotate all eight clips out of with its high voltage circuitry presents a health hazard that the way. could result in death, serious bodily injury, and/or property 3. ...
  • Page 6: Wiring Diagram

    6 Wiring Diagram BLOWER SPEED CNTRL TRIAC FILTER PRESSURE CHECK SWITCH LIGHT 120v 60Hz single phase Toll-Free 1-800-533-7533 www.UsePhoenix.com • sales@UsePhoenix.com...
  • Page 7: Service Parts

    7 Service Parts Optional Parts Item Part No. Description 4031878  Air Filter, Disposable Carbon/ 1   4031877    Air Filter, Pleated, 1” x 18” x 18” Potassium Permanganate 2  4031864    Air Filter, HEPA, 2.5” x 18” x 18”  4028357  Duct, Flex, 16” x 25’       (99.97% Efficient) 4024935  Duct, Lay Flat, 10” x 250’ 3  4031863    HEPA filter hold down clip 4  4035832    Impeller Fan 5  4032854    Impeller Fan Speed Control 6 ...
  • Page 8 This page intentionally left blank. Toll-Free 1-800-533-7533 www.UsePhoenix.com • sales@UsePhoenix.com...
  • Page 9: Warranty

    Phoenix Guardian R HEPA System Limited Warranty Warrantor: Therma-Stor LLC 4201 Lien Rd Madison, WI 53704 Telephone: 1-800-533-7533 Who Is Covered: This warranty extends only to the original end-user of the Guardian R HEPA System, and  may not be assigned or transferred. First Year Warranty: Therma-Stor Products warrants that, for one (1) year the Guardian R HEPA System  will operate free from any defects in materials and workmanship, or Therma-Stor Products will, at its  option, repair or replace the defective part(s), free of any charge. End-User Responsibilities: Warranty service must be performed by a Servicer authorized by Therma-Stor Products. If the end-user is unable to locate or obtain warranty service from an authorized Servicer, he ...

This manual is also suitable for:

4031460Guardian r

Table of Contents