icklebubba Galaxy User Manual
  1. Manuals
  2. Brands
  3. icklebubba Manuals
  4. Car Seat
  5. Galaxy
  6. User manual

icklebubba Galaxy User Manual

Hide thumbs

Advertisement

Table of Contents

Galaxy Car Seat
User Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Galaxy and is the answer not in the manual?

Questions and answers

Summary of Contents for icklebubba Galaxy

  • Page 1 Galaxy Car Seat User Guide...

  • Page 2: Table Of Contents

    CONTENTS Dear Parents Congratulations on the purchase of your Galaxy car seat. Studies have shown that a large percentage of car seats are not installed correctly. Your child’s safety can only be guaranteed if this product is used according to these instructions.

  • Page 3: Restraint Features

    RESTRAINT FEATURES 1.Shell 14.Rear Belt Hook for Shoulder 2.Support Pillow Section of Safety Belt 3.Shoulder Pad 15.Button for Releasing Car Seat from 4.Carrying Handle the Stroller 5.Push Button for Adjusting 16.Lever for Releasing Car Seat from Carrying Handle Isofix Base 6.Sun Canopy 17.Isofix Connector Button.

  • Page 4: Important Information

    ECE R16 standard or similar. The Galaxy car seat may be used in the front seat and in the rear seat. Always place the baby car seat rearward facing. Lock rear seats that fold down.
  • Page 5 IMPORTANT The seat may become unsafe after an accident due to damage that is not immediately noticeable. It should therefore be replaced. The manufacturer can only guarantee the safety of the seat if it is used by the original owner. We strongly advise against using a second-hand product, as you can never be sure of its history.

  • Page 6: Instructions For Use In The Car

    INSTRUCTIONS FOR USE IN THE CAR Always check to make sure the seat fits in your car properly before purchasing it. The seat must always be secured, even when not in use. An unsecured seat can injure other passengers in the car in the event of an emergency stop.

  • Page 7: General

    GENERAL Sun Canopy Fitting the canopy on to the car seat 1. Attach the adapters. 2. Hook the elastic loops of the canopy on to the adapters (both sides). 3. Pull the back of the canopy over the back of the car seat. 4.
  • Page 8 PLACING YOUR CHILD IN THE GALAXY CAR SEAT Loosen the shoulder belts by pressing the quick adjuster button, (A1) and pulling the shoulder belts towards you (A2). Release the belt buckle and drape the belts with the tongue sections over the two sides of the seat (B). Pull the buckle for- ward, attach the loop of the belt pad over the edge of the quick adjuster button.
  • Page 9 PLACING YOUR CHILD IN THE GALAXY CAR SEAT G Headrest Adjustment Method Push the button to release the buckle and pull the headrest adjuster (G2) to move it up and down before choosing a suitable position for the headrest (3).

  • Page 10: Seatbelt Installation

    SEATBELT INSTALLATION Our product can be fitted safely on almost all forward-facing seats in the car using the existing seat belts. However, the belts are fitted so far forward on some seats that proper installation is not possible. If this is the case, try another seat. In some cases, the buckle of the safety belt may be too long and therefore sits too high against the base of our product, making it difficult to install the baby car seat securely.
  • Page 11 SEATBELT INSTALLATION...
  • Page 12 SEATBELT INSTALLATION Important! Do not mix up point (H-1) and shoulder strap (H-1) Place the baby car seat in a rearward-facing position on the seat. The carrying handle must be locked in an upright position (H-2). Thread the lap section of the seat belt across the front (foot end) between the shell and the two blue belt hooks (H-3).

  • Page 13: Isofix Installation

    ISOFIX INSTALLATION Fold out the support leg fully and place the car seat base onto the vehicle seat. Squeeze together the isofix adjustment buttons located on either side of the sup- port leg at the front of the car seat base and pull the support leg towards the seat base to extend the isofix attachment points.
  • Page 14 ISOFIX INSTALLATION When the isofix points are correctly attached the isofix connection indicators will turn green. If the indicators remain red you must release and re- connect the isofix points. To do this see section “Disas- sembly” on page 15 (J-11). Please pick up the seat and fix it on the three slots of the base.
  • Page 15 ISOFIX INSTALLATION Push the baby seat firmly against the backrest to lock it into the isofix fittings. Check the indicator light to confirm your baby seat is correctly installed. Adjust the leg to the right height by pressing this button. Make sure the leg is stable against the floor and lock it firmly into position and check the indicator light...

  • Page 16: Disassembly

    DISASSEMBLY Press the release button and pull the handle upwards to remove the car seat from the base. Unlock the isofix points by pulling the latches towards the front of the vehicle seat. Pull the car seat base away from the back seat to release from the vehicle.

  • Page 17: Maintenance

    MAINTENANCE General Remove the car seat from the car before carrying out any maintenance work. The seat can be cleaned with soap and lukewarm water. Do not use any abrasive detergents. The belt buckle can be cleaned using warm water. Do not lubricate.

  • Page 18: Warranty

    WARRANTY We guarantee that this product was manufactured in accordance with the current European safety requirements and quality standards applicable to this product, and is free from defects in workmanship and material at the time of purchase. During the production process the product was subjected to various quality checks.

  • Page 19: Waste Separation

    WASTE SEPARATION To ensure optimum and safe use of car safety seats, they should not be used for longer than 5 years after the date of purchase. Once your child has outgrown the baby car seat, we therefore advise you to no longer use the the car seat and dispose of it in the proper way.

Table of Contents

Save PDF