Replacing The Hpl Lamp - ETC Source Four PARNel User Manual

Step 3: Lock the retaining clip by pushing sideways while gently pushing forward.
N o t e :
N o t e :
R e p l a c i n g t h e H P L l a m p
A lamp must be installed before you use the fixture.
N o t e :
W A R N I N G :
Step 1: Disconnect power to the fixture before installing the lamp.
Step 2: Loosen the knurled bolt on the back of the lamp housing and pull the housing out.
Step 3: Holding by the base, remove the HPL lamp from its box.
C A U T I O N :
Basic Assembly
Use only color frames or accessories with 7.5 inch mounting flange.
The performance of saturated colors may be less than desirable in any theatrical
lighting fixture, especially when equipped with a 750w lamp. For best results,
always use high-quality color media rated for high-temperature use.
ETC's optional Gel Extender, part # PSF1029, will provide maximum color media
life. The use of any gel extender accessory may limit the coverage of any wide-
angle lens or beam setting.
A variety of heat shield products is also available from many color media
manufacturers. Follow the manufacturer's instructions for the use of these
products.
Lamp retention
brackets
Knurled bolt
Verify that the HPL lamp you intend to install is suitable for your facility's voltage;
115-, 120-, 230-, and 240-volt HPL lamps are available.
See HPL lamp table, page
reduces lamp life and can cause premature lamp failure.
Unplug the fixture and allow it to cool down before attempting to change the
lamp.
Use caution when installing or replacing any lamp.
When installing/replacing lamp, be sure to point the lamp away from your face and
away from others before inserting it firmly into the assembly.
This may prevent injuries if the lamp should break.
INCORRECT
HPL lamp
Lamp housing
2. Operating HPL lamps above their rated voltage
Figure 3
CORRECT
3