Creative T3250 Quick Start Manual

1
1
Enjoy audio from Bluetooth devices
a. Powering Up the speaker
Power on the speaker by turning the
volume dial in the clockwise direction.
The LED status indicator will lit steady
indicating the speaker is currently ON.
b. Establish Bluetooth Connection
Press and hold the Bluetooth button
and release when the LED starts
blinking rapidly.
Pairing

Product overview

6
1
3
c. On Bluetooth device
. Turn ON the Bluetooth feature on your dev ce.
. Search for Creat ve T3250W.
. Pa r and connect to Creat ve T3250W. If prompted for passcode, enter 0000.
v. Pa r ng successfu , ready to stream mus c.
i. ii. ii. iv.
Note: The above are generic steps to pair
Creative T3250W Creat ve T3250W
Connectivity Connect vity
Bluetooth Search results PASSCODE CONNECTED
ON
Network Creative T3250W
0000
Connections
Operator
Internet
USB
®
d. Ready to stream music via Bluetooth
Turn volume dial clockwise or
anti-clockwise to increase or decrease
volume. You may also adjust your
source device volume settings to
increase or decrease volume.
2
5
2
2
Reconnections between
Bluetooth device and
Creative T3250W
You can reconnect your paired Bluetooth device to your speaker easily.
Select 'Creative T3250W' entry on the Bluetooth device to reconnect any of the 4 previously
connected Bluetooth devices would be able to reconnect to Creative T3250W when the
T3250 Wireless is powered ON and not connected to any device.
Note: he Creative 3250 Wireless is able to remember up to 4 paired devices in its memory bank, eliminating
to a Bluetooth device, for more the need to re-pair again should any o these devices connect to the Creative 3250W Should a 5th
specific instructions on Bluetooth device be paired to the 3250W, the 1st device will be erased rom the 3250W s memory banks At any
one time a maximum memory o 4 devices are being retained
connectivity for your device, please
consult your manufacturer's
manual.
3
3
Power Saving Mode
The speaker enters power saving mode when there is no Bluetooth connection
or no audio signal detected on the Line-In connection for more than 15 minutes.
It is recommended to power off when the speaker is expected to be unused for
several days.
7
1 LED status indicator
LED Status Speaker Status
Lit steady
Powered ON (Idle) or
connected to any
®
Bluetooth devices
LED rapid blinking
Pairing Mode
2 ON / OFF Switch / Volume
4
3 Bluetooth Connect button
4 To Wall Outlet
5 3 5mm analog stereo mini plug
6 Left speaker
7 Right speaker