G4S SmartAlarm P5 User Manual

Alarms and false alarms
The panel sends an alarm signal to the Monitoring Service. The Monitoring Service will
then respond as arranged with you. Typically, a guard will be dispatched to your home.
If you arrive at the panel when the alarm condition is active - with a sounding siren
(the siren falls silent after 3 min.) and the red LED flashes do the following:
1) Press the key to display the activated sensors.
2) Then enter your user code. Services are now turned off and a 'clear' message is
automatically sent to the Monitoring Service. The red LED will continue to flash until
the panel is reconnected, or if you browse through the event log.
If you want information about where in the house the alarm is enabled do the
following:
1) Enter followed by the code
2) Select the event log by pressing 6-1, use the
events.
3) To finish viewing the event log press the
If you have caused an alarm by mistake, it must be reported to the Monitoring
Service. This must be done immediately after you have caused the alarm:
1) You can cancel a false alarm simply by entering your user code.
This stops the siren and sends a message to the Monitoring Service if the alarm is
turned off by an authorized user.
Control your alarm online
APP - for Smartphone
"mitG4S" allows you to control and monitor your G4S SmartAlarm P5 from your Wi-Fi or
3G Iphone, Smartphone or android.
With G4S's "mitG4S" you can arm and disarm your alarm, change contacts, etc.
The app is available for Android phones and tablets on the Android Market and the App
Store for iPhone and iPads.
Customer log in via www.G4S.dk
Useful phone numbers:
Monitoring Service:(+45) 70 33 22 11
Contact Center :(+45) 70 33 00 40
and keys to view previous
key 3 times.
G4S Security Services A/S
Roskildevej 157
2620 Albertslund
Phone: (+45) 4386 5000
User M anual
SmartAlarm – P 5