Amplifier, Tuner - Motorola DRC800 User Manual

Programming – code input method
Each of the additional device keys controls a particular type of device. For example, the DVD/VCR
key controls your VCR, DVR, or DVD player, but not your TV, unless you specify otherwise. See
"Reassigning device keys".
This device key...
TV
DVD/VCR
CABLE
AUDIO
1. Find the device you want to control in the device code list.
2. Press and hold a device key (AUDIO, DVD/VCR, or TV) until the mode indicator lights cycle
through all modes and lands back on the mode key you selected. Mode key selected
indicator light will remain on.
3. Enter the four-digit code. The indicator light will...
a. Blink 3 Times – confirms code successful, test remote by pressing keys to see if unit
responds. If not, repeat these steps with a different code.
b. Goes out – code unsuccessful, repeat all steps.
Note: if no codes work, please try programming using the "Programming – code search
method".
Programming – Code search method
1. Press and hold a device key (AUDIO, DVD/VCR, or TV) until the mode indicator lights cycle
through all modes and lands back on the mode key you selected. Mode key selected
indicator light will remain on.
2. Press a function key (such as POWER or MUTE). The following function keys are valid for
searching (Power is recommended):
• Power
• Mute
• Play
• CH+
• Stop
The mode key indicator light will turn off.
3. Press [UP] on the directional pad. The remote will send the IR command for the function
you pressed in step 2.
4. If the device performed the function you pressed, press [OK] key. The remote will now
control the device you selected in Step 1. If the device did not perform the function you
pressed, repeat step 3. Press [DOWN] on the directional pad to retry previous code.
Controls this type of device...
TV
DVD, VCR, DVR, HTIM, TV/VCR, TV/DVD,
TV/VCR/DVD, AND DVD/VCR
Cable box only
AMPLIFIER, TUNER