Setting The Device Id Number (Device Id); Switching The Pedal's Polarity (Pedal Polarity); Setting The Keyboard Touch (Key Touch); How To Make Settings - Roland RD-700 Owner's Manual

Parameter
Control Channel
NOTE
When the Control Channel settings are transmitted along
with the part's MIDI receive channel, switching of Setups
takes priority over the switching of tones.
For more information about "Switching Setups" (p. 97).
Setting the Device ID Number
(Device ID)
The Device ID number is an identification number used
when transmitting and receiving MIDI Exclusive messages.
When transmitting Exclusive messages, the device ID
numbers of the corresponding devices must be matched.
Parameter
Device ID
Switching the Pedal's Polarity
(Pedal Polarity)
Switch the polarity of pedals connected to the RD-700.
This can be set individually for each of the Pedal jacks on the
rear panel (FC1, FC2, DAMPER).
On some pedals, the electrical signal output by the pedal
when it is pressed or released is the opposite of other pedals.
If your pedal has an effect opposite of what you expect, set
this parameter to Reverse.
If you are using a Roland pedal (that has no polarity switch),
set this parameter to STANDARD.
Parameter
Damper
FC1 STANDARD, REVERSE
FC2
Value
1–16, OFF
Value
17–32
Value
Detailed Settings for Each Function ([EDIT])
Setting the Keyboard Touch
(Key Touch)
You can make advanced settings for the touch used for the
keys.

How to Make Settings

1. Press [EDIT], getting the indicator to light.
The Edit Menu screen appears.
fig.Editmenu1.eps_150
2. Press CURSOR [
3. Press CURSOR [
fig.keytouch1.eps_150
4. Press CURSOR [
parameter to be set.
5. Press [INC/YES] or [DEC/NO] to set the value.
6. When you have finished making the settings, press
[EDIT], extinguishing its indicator.
You are returned to the Tone screen.
]/[ ] to select "1.Key Touch."
] to display the Edit screen.
] or [ ] to move the cursor to the
71