Download Print this page
Innokin itaste mvp 2.0 User Manual

Innokin itaste mvp 2.0 User Manual

Advertisement

Quick Links

USER MANUAL
MVP 2.0
WARNING:
Please read the instructions and precautions before
using the iTaste MVP
1. The iTaste MVP is intended for use by people of legal
age (18+), NOT by non-smokers, children, women
who are pregnant or breastfeeding, people with or
at risk of heart disease or people taking medication
for depression or asthma. The iTaste MVP is neither
intended for or marketed as a quit smoking aid or
cessation device.
2. This unit may include small parts, please keep out of
reach of children and pets.
3. Don't abuse your iTaste MVP even though it's made
of metal, you may damage it by dropping it.
4. Don't attempt to repair the unit by yourself as
damage or personal injury may occur.
5. In order to guarantee the normal function of your
iTaste MVP and maintain the effect of vaping, we
suggest that you charge your batteries when they are
below 10% power.
6. In order to prolong the function of your iTaste MVP ,
please don't place it in any environment that is too
hot or too cold too hot or too cold environment.
7. Please obey local laws or regulations while vaping. If
there are any bans or potential dangers, please keep
the iTaste MVP off.
8. Your iTaste MVP is not waterproof, please keep it dry.
9. Keep your iTaste MVP from sources of excessive heat.
10.Please don't drop, throw or abuse your iTaste MVP ,
you may cause damage to outer shell or Inner
components.
11.Innokin is not responsible for battery or charge cable
explosions due to the use of low quality wall charger.
iTaste MVP doesn't come with any wall charger . We
recommend you use high quality USB wall charger
with 5V 500mA (CE&UL certified) . This will takes you
about 2.5h fully charge your iTaste MVP .
12.Use lower wattage for low-resistance (ohms)
accessories and higher wattage for high-resistance
(ohms) accessories
Warranty
Please consult with Innokin official distributors for their
warranty and return policy. Innokin's warranty does
not apply to products purchased through third party
vendors.
ITaste MVP is a microprocessor controlled VV/VW
personal vaporizer that lets you easily adjust the
voltage and wattage with just a few button presses.
Specifications:
23*41*107mm
Size :
Operating Voltage :
3.3V-5.0V
6.0W-11.0W
Operating Wattage :
Battery capacity :
2600m Ah
Main Features:
Variable Voltage:
voltage can be adjusted from 3.3 – 5.0 volts in .1 volt
increments.
Variable Wattage:
Wattage can be adjusted from 6.0 – 11.0 W in .5 watts
increments.
Ohms meter :
Reads resistance of your atomizer/cartomizer/clearomizer.
Puff Counter:
Puff counter will record the number of puffs you have
taken. Either press "P "button or "U" button 1 second
to check puffs ,The Puff Counter will be cleared when
the device is turned off.
Short Circuit/Atomizer Protection:
Short Circuit/Atomizer Protection protects the iTaste
MVP against shorted atomizers.
Over-Discharge Protection:
The iTaste MVP monitors the battery voltage and will
automatically turn off when the battery is discharged.
Battery Level Indicator:
The iTaste MVP battery capacity is displayed via
green, yellow and red LED lights.
Green = Fully Charged
Yellow = Half Discharged
Red = In need of charging
Large battery capacity:
iTaste MVP e-cigarette built-in 2600 mAh polymer
Li-Ion rechargeable battery.
High compatibility 510 connector:
Thread fit iClear10,iClear16 ,iClear30 etc
ON/OFF battery switch:
Quickly clicking"
"three times will enable or disable
the battery. Once enabled, holding down the button
will activate the battery.
This safety feature prevents the atomizer from
turning on while it's in your pocket or bag and it
prevents any settings from getting changed without
you knowing.
10 seconds cutoff:
If the button is held down for 10 seconds or longer,
the iTaste MVP will shut itself off until the button is
released and pressed again.
Passthrough:
The iTaste MVP uses a built in Micro USB Port. You can
recharge it with a Micro USB cable. It can also work as
a pass-through for use while charging.
Remembers last set voltage or wattage :
Remembers last set voltage or wattage when the
battery is turned off and then back on.
Built-in 3 digit display :
Digital display shows Ohms meter, Voltage /Wattage
setting, number of puffs taken since last time the
battery was turned off.

Advertisement

loading
Need help?

Need help?

Do you have a question about the itaste mvp 2.0 and is the answer not in the manual?

Questions and answers

Summary of Contents for Innokin itaste mvp 2.0

  • Page 1 3.3 – 5.0 volts in .1 volt components. High compatibility 510 connector: Please read the instructions and precautions before 11.Innokin is not responsible for battery or charge cable increments. Thread fit iClear10,iClear16 ,iClear30 etc using the iTaste MVP explosions due to the use of low quality wall charger.
  • Page 2 Portable power source for electronic products 3.Green LED light = battery voltage is more than 3.75 V Function description counter first followed by the last adjustment (The last adjustment may be a voltage or wattage setting), 4.Red LED will keep blinking for 8 seconds when battery Turn ON the small pin switch in bottom of iTaste MVP, iClear dual coil clearomizer connect cable into USB OUTPUT port(DC 5V ,...