Amplifier And Control Panel Installation; Connecting Your Speakers; Bluetooth Connection; Aux Connection - Lepai LP40PA Operating Manual

AMPLIFIER AND CONTROL PANEL INSTALLATION

The plate amp panel requires a cutout 2.75" x 1.75" (70 x 45 mm) with at
least 2.625" (67 mm) depth. Mount the plate to your master speaker cabinet,
and connect the included output leads to the terminals of your speaker or
crossover network, observing correct polarity.
The control panel requires a cutout approximately 2.6" x 0.79" with at least 1"
of the panel. Therefore, you may wish to cut a test hole(s) in a piece of scrap
once this has been determined.
Connect the control panel to the amp panel using the included leads, then
press the control panel into place.

CONNECTING YOUR SPEAKERS

With the power turned OFF, use high quality wire for the connection between
the Master and Slave speakers. For distances up to 10 feet, conventional
18AWG wire is acceptable. For longer runs, heavier wire should be used. For
proper performance please observe correct polarity.

BLUETOOTH CONNECTION

Turn the power switch ON. The speaker will enter pairing mode, and the LED
select "LP40PA". You will hear two beeps when pairing is complete, and the
LED will remain solid blue.

AUX CONNECTION

Plug your device into the AUX jack on the Master speaker using a 3.5 mm
stereo cable (not included). The LED indicator will light solid red to indicate
AUX connection.
PLEASE NOTE: for the best sound quality in Bluetooth or AUX mode, we
recommend that your device's volume level be set no higher than 90%.

SPECIFICATIONS

Power Output:
Minimum impedance:
Power input:
Frequency response:
THD + N:
Bluetooth version:
Bluetooth range:
20W x 2 RMS; 40W x 2 peak
4 ohms
18VDC, 2A (AC adapter included)
20 - 20,000 Hz
<0.7%
4.2
Up to 30 meters