Hochiki DFG-60E Installation Instructions

HOCHIKI DFG-60E WATERPROOF HEAT DETECTOR
INSTALLATION INSTRUCTIONS
General Description
The DFG-60E detector is designed for areas that are exposed to water, and provides reliable heat detection
with a slow or fast change in temperature. It is particularly suited to environments that are exposed to high
levels of condensation or are hosed down and has a wide operating margin allowing it to respond to both
slow and fast increases in temperature. It can also sense temperature reliably in a horizontal or vertical
position.
The detector is supplied with a set of flying leads for direct connection to the conventional zone and remote
LED (if required) and does NOT require any form of standard detector base.
WIRING
The wiring of the DFG-
60E waterproof heat
detector should be made
as shown right:
Mounting
If a back box is required then the DFG-60E can be mounted using the MK Red Alert surface mounting
range, for example the YCR/502.
Specifications
Ordering code
Operating Voltage
Standby current
Current in alarm state
Ambient temperature range
Storage temperature range
IP Rating
Fixing centres
Colour and case material
Weight
DFG-60E
15 - 30Vdc (Nominal rating 24Vdc)
Zero
50mA at 24Vdc
-10°C to +60°C
-30°C to +70°C
IP67
70mm
Ivory - modified polycarbonate
80g