Gree E2CORD-230V30A Installation Instructions

Accessory Power Cord Assembly for
E-TAC II Packaged Terminal Air Conditioners
Models:
E2CORD-230V15A E2CORD-265V15A
E2CORD-230V20A E2CORD-265V20A
E2CORD-230V30A E2CORD-265V30A

POWER CONNECTION CHART

Unit Model
15A (2.5KW)
ETAC2-07HC230VA-A
ETAC2-09HC230VA-A
ETAC2-12HC230VA-A
ETAC2-15HC230VA-A E2CORD-
230V15A
ETAC2-07HP230VA-A
ETAC2-09HP230VA-A
ETAC2-12HP230VA-A
ETAC2-15HP230VA-A
ETAC2-07HC265VA-A
ETAC2-09HC265VA-A
ETAC2-12HC265VA-A
E2CORD-
ETAC2-15HC265VA-A
265V15A
ETAC2-07HP265VA-A
ETAC2-09HP265VA-A
ETAC2-12HP265VA-A
ETAC2-15HP265VA-A
* Using 30A on these units could result in damage to your unit.
SAFETY PRECAUTIONS – Please read the following before installation.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
W RNING This mark indicates procedures which, if improperly performed, might lead to the death or serious injury of the user.
This mark indicates procedures which, if improperly performed, might possibly result in personal harm
C UTION
to the user, or damage to property.
Notice is used to highlight suggestions which will result in enhanced installation, reliability and operation.
NOTICE
W RNING
– Electrical shock hazard and/or unit operation and damage hazard
Failure to follow this warning could result in personal injury or death and/or unit operation and damage. Installing and servicing air conditioning equipment
can be hazardous due to system pressures and electrical components. Only trained and qualified personnel should install or service air conditioning
equipment. When working on air conditioning equipment, observe the precautions provided in literature, tags and labels attached to the unit.
1. Follow the National Electrical Code (NEC) or local codes and ordinances.
2. For personal safety, this unit MUST BE properly grounded.
3. Protective devices (fuses or circuit breakers) acceptable for unit installations are specified on the nameplate of each unit.
4. DO NOT use an extension cord with this unit.
Electric Heater - Amp (KW)
20A (3.5KW) 30A (5.0KW)
230/208 VOLTS
Not Available
E2CORD-
230V30A
E2CORD-
230V20A
Not Available
E2CORD-
230V30A
265 VOLTS
Not Available
E2CORD-
E2CORD-
265V30A
265V20A
Not Available
E2CORD-
265V30A
INSTALLATION INSTRUCTIONS
208/230v LCDI Power Cord (1)
*
265v Power Cord (1)
*
Wire Clamp (1)
* Only one power cord provided depending on kit ordered.
Screw (1)